Hardware Connections; Front Panel And Connectors; Rear Panel And Connectors - ZyXEL Communications ZyXEL ZyWALL 35 Quick Start Manual

1 Hardware Connections

1.1 Front Panel and Connectors

Refer to section 1.3 on how to setup your ZyWALL.
LABEL
RESET You only need to use this button if you've forgotten the ZyWALL's password. It returns
the ZyWALL to the factory defaults (password is 1234, LAN IP address 192.168.1.1,
terminal emulation settings as described below etc.; see your User's Guide for details).
WAN 10/100 These ports are auto-negotiating (can connect at 10 or 100Mbps) and auto-crossover
1/2 (automatically adjust to straight-through or crossover Ethernet cable).
LAN/DMZ These ports are auto-negotiating (can connect at 10 or 100Mbps) and auto-crossover
10/100 (automatically adjust to straight-through or crossover Ethernet cable).
1-4

1.2 Rear Panel and Connectors

LABEL
DIAL BACKUP Only connect this port if you want to set up a backup WAN connection; see your User's
Guide for details.
CONSOLE Only connect this port if you want to configure the ZyWALL using the SMT (System
Management Terminal) via console port; see your User's Guide for details.
Your computer should have a terminal emulation communications program (such as
HyperTerminal) set to VT100 terminal emulation, no parity, 8 data bits, 1 stop bit, no flow
control and 9600 bps port speed.
ZyWALL 35 Internet Security Appliance
2
DESCRIPTION
DESCRIPTION