5.2.2
Service Class 2 Commands
The following Class 2 commands are supported and implemented as per TIA PN2388 (8/20/90):
COMMAND SYNTAX
+<command>=<value>
+<command>=?
+<command>?
Table 5-9 Service Class 2 Commands Supported Commands (per TIA PN2388 8/20/90)
COMMAND
+FAA=n
Automatic answer mode parameters.
Answer as set by +FCLASS.
DCE answers and automatically determines the type of call.
+FBADLIN=
Bad line threshold (number of consecutive bad lines for a bad page
<value>
parameter).
Determine if Copy Quality is OK on the T.30 flow chart. A value of 0
implies that error checking is disabled.
+FBOR=n
Phase C data bit order:
Select direct bit order.
Select reversed bit order in receiving mode for phase C data.
+FBUF?
Buffer size. This Read Only parameter allows the DTE to determine the
characteristics of the DCE's buffer size.
+FCIG="string"
Sets the local fax station ID string that is sent to polling Rx.
+FCLASS=n
Service class selection. Refer to the +FCLASS Service Class 1 command
in Table 5-6.
+FCON
DCE automatically responds to a fax connection.
+FCQ=n
Sets the copy quality check capability parameters.
Disables the copy quality check capability.
Command Sets
Table 5-8 Service Class 2 Command Syntax
DESCRIPTION
Omni 56K II and Omni 56K Plus II User's Guide
DESCRIPTION
Execute a command or set a parameter.
Read permissible settings.
Read current setting.
VALUE
n=0
n=1
0-255
n=0
n=1
n=0
5-13