Connecting The Hardware - Zoom 4401 User Manual

Connecting the Hardware

1
Put the AP+4 near a computer to be used for setup. That
computer needs an Ethernet (LAN) port.
2
Turn off the computer.
3
Connect one end of the supplied power cube to the AP+4
PWR jack, and the other end to a live power source.
Important! Only use the power cube shipped with the AP+4.
Other power cubes may damage the device.
The PWR LED on the AP+4 front panel should turn on and
the WLAN LED should flash. (The WLAN LED continues to
flash to signify broadcast activity as long as the Wireless
LAN is enabled. It is enabled by default.)
4
Connect one end of the supplied Ethernet cable to the
computer's Ethernet port and the other end to one of the
AP+4's LAN ports.
5
Turn on the computer.
The WLAN LED continues flashing and the connected LAN
port and the ACT (Activity) LEDs become steady on. (If you
have a 10 Mbps Ethernet connection, the LAN LED does not
turn on.)
If you want the AP+4 to have access to the Internet, connect
its WAN port to the Ethernet port on your cable modem,
ADSL modem, or other broadband device. When you do
this, the WAN LED turns on if the broadband device is on
and its Ethernet port is working.
Chapter 1. Installing the AP+4 7