Cerwin-Vega CVPRO PRO Series User Manual page 5

Installation
5. Prepare the ground wire for attachment to the amplifier by stripping 5/8" of insulation from the end of the wire. Always
use a wire of the some gauge as the power connection, never smaller. Insert the bare wire into the GND terminal and
tighten the set screw to secure the cable in place. Prepare the chassis ground by scraping any paint from the metal surface
and thoroughly clean the area of all dirt and grease. Strip the other end of the wire, crimp and soldier a ring connector.
Fasten the cable to the chassis using a non-anodized screw with a star washer.
WARNING: It is important to upgrade the ground
connection between the negative (-) battery post and the
vehicl e body or chassis to achieve optimum electrical
performance.
6. Prepare the REM turn on wire for attachment to the amplifier
by stripping 5/8 inch (15.9mm) of insulation from the end
of the wire. Insert the bare wire into the REM terminal and
tighten the set screw to secure the wire in place. Connect
the other end of the REM wire to a switched 12 volt positive
source. The switched voltage is usually taken from the
source unit's remote amp turn on lead. If the source unit
does not have this output available, the recommended
solution is to wire to an accessory terminal in the cars fuse
block using a relay to isolate the amplifer from the vehicles
accessory circuit. This however will turn the amplifier on and
off with the ignition key, regardless of whether the car stereo
is on or off.
7. Securely mount the amplifier to the vehicle or amp rack. Be careful not to mount the amplifier on cardboard or plastic
panels. Doing so may enable the screws to pull out from the panel due to road vibration or sudden vehicle stops.
8. Connect from source signal by connecting the RCA audio cables to the input jacks at the amplifier.
9. Connect the speakers. Speakers impedance should NEVER be less than 1 Ohms MONO ( The 3K AND 5K are stable into
l ohm). For most applications 16 gauge wire is adequate for the speaker leads. For leads in excess of ten feet 12 gauge
wire is recommended. Strip the speaker wires 1/2" (12.7mm) and insert into the speaker terminal block, then tighten the
set screw to secure into place. When wiring the speakers, pay careful attention to the polarity of the terminals on the
speakers and make certain they correspond to the polarity on the amplifier. DO NOT chassis ground any of the speaker leads
as unstable operation or damage to the amplifier and/or speaker may result.
FUSE CONNECTION DIAGRAM
* FUSES SHOULD BE EQUAL TO 1/2
RCA CONNECTION DIAGRAM
CVPRO3K = 200A
CVPRO5K = 300A
OF FULL POWER CURRENT DRAW
1
H71200.1D/H718
5