Control - Roland D-05 Parameter Manual

SPLIT
(Split Point)
Neo Horizon
DUAL SP C4
This specifies the split point that is used when the KEY MODE
(key mode) is set to SPLIT (split), SPL-US (split upper solo), or SPL-
LS (split lower solo).
The Split Point can be changed as follows.
1
In the main screen, press the
use the [INCREMENT] [DECREMENT]
the parameter.
Value: C2–C7
C2–B2 C3–B3
(middle C)
BALANCE
(Tone Balance)
The volume balance of the Upper and the Lower Tone can be
change.
1
In the main screen, press the
The page changes.
Neo Horizon
Bal 00 Trns 00
2
Press the [F1] (Bal) button, and then use the
[INCREMENT] [DECREMENT]
parameter.
Value: 0–100
TRANSPOSE
(Transpose)
The pitch range of the keyboard can be transposed (shifted) in
semitone steps.
1
In the main screen, press the
The page changes.
Neo Horizon
Bal 00 Trns 00
2
Press the [F2] (Trns) button, and then use the
[INCREMENT] [DECREMENT]
parameter.
[SHIFT]
If you hold down the
[DECREMENT]
buttons to edit the parameter, the value changes
in steps of one octave (12 semitones).
Value: -36–0–+36
[F2] (SP) button and then
buttons to edit
C4–B4 C5–B5 C6–B6
[ ] button.
buttons to edit the
[ ]
button.
buttons to edit the
[INCREMENT]
button and use the
CHASE
(Chase Button)
Switches the Chase function (p. 4) on and off.
Value:
OFF, ON
PORTAMENTO
(Portamento Button)
C7
Switches the Portamento function on and off. Portamento is
a slide from one pitch to another, and is often used for violin
performance.
Value:
OFF, ON

CONTROL

These parameters specify how the control functions affect each
patch.
Control Edit
Bend 05 AfPB 00
Bend
(Bender Range)
This specifies the available range of pitch change when you
operate pitch bend.
The variable range set here may result differently depending on
the setting of the Tone Parameter Bender Mode (p. 12).
Value:
0–12
AfterPB
(Aftertouch, Pitch Bender)
This sets the sensitivity of the aftertouch effect on pitch. Higher
values mean higher sensitivity. A Minus setting decreases the
pitch, and a plus setting increases it.
Value:
-12–+12
Port
(Portamento Time)
This sets the portamento time from one note to another. Higher
values make the time longer.
Value:
0–100
3
Basic Operation