Rear Panel - Zenith XBS245 Installation And Operating Manual

Rear Panel

VCR IN LINE 1 (VIDEO IN/AUDIO IN (Left/Right))
Connect the audio/video output of an external source
(Audio system, TV/Monitor, Another VCR).
RF OUT (DVD/VCR OUT)
Connect to a TV with RF coaxial inputs.
Connect the VHF/UHF/CATV antenna to
AC Power Cord
Plug into the power source.
Connect to a S-Video Input on TV.
Select either S-VIDEO OUT or COMPONENT VIDEO OUT/PROGRESSIVE
SCAN, depending on how you connected the DVD+VCR to the TV.
Dust Protection Cap
Remove the dust protection cap from the
OPTICAL DIGITAL IN jack and connect the
optical digital cable (not supplied) securely
so that the configurations of both the cable
and the connector match. Keep the dust
protection cap and always reattach the cap
when not using the connector to protect
against dust intrusion.
10
ANT.IN
this terminal.
S-VIDEO OUT (DVD OUT)
FOR DVD VIEWING ONLY.
DIGITAL AUDIO IN (OPTICAL)
Connect to a digital audio output on a digital device.
DVD/VCR OUT (VIDEO/AUDIO (Left/Right))
Connect to a TV with video and audio inputs.
COMPONENT VIDEO OUT/PROGRESSIVE SCAN
(Y Pb Pr) (DVD OUT)
Connect to a TV with Y Pb Pr inputs.
VIEWING ONLY.
VIDEO OUTPUT Switch
FM Antenna Connectors
Connect the FM antenna to this terminal.
AM Antenna Connectors
Connect the AM antenna to this terminal.
Connect the six supplied speakers to these terminals.
Do not touch the inner pins of the jacks on the rear
panel. Electrostatic discharge may cause permanent
damage to the unit.
FOR DVD
SPEAKER Connectors