Start The Programme; How To Change A Programme During Its Cycle; How To Cancel A Programme During Its Cycle; How To Open The Door During The Cycle Of A Programme - Zanussi ZWF 1434W Instruction Booklet

11. Start the programme

Press the Start/Pause button. The relevant light will stop
flashing and only the light relevant to the phase that is in
progress will remain lit.
If you have chosen a delayed start, the washing machine
will begin the countdown.
The display will show the duration of the programme or
the selected delay.
12. How to change a programme
during its cycle
Before you make any change, you must pause the
washing machine by pressing the Start/Pause button.
It is possible to change any phase before the programme
carries it out.
Changing the type of fabric or temperature is possible,
obviously, only during the washing phase. When you
make a change in these two parameters, the washing
machine will resume the cycle from the beginning.
If it is necessary to drain the water in order to change the
programme in progress, proceed as follows:
• PAUSE the machine by pressing the Start/Pause
button;
• press the Skip Reset button repeatedly, until only the
Drain light remains lit;
• press the Start/Pause button again.
When the water has been drained, the display shows a
flashing zero. You may now select a new programme
and press the Start/Pause button to start it.
13. How to cancel a programme
during its cycle
To cancel a programme that is being carried out, first
pause the washing machine by pressing the Start/Pause
button, then press the Skip Reset button repeatedly, until
the display shows three flashing dashes.
14. How to open the door during
the cycle of a programme
You can open the door, after having set the washing
machine to Pause, provided the following conditions
exist:
• the washing machine is not in the heating phase
beyond 55°C;
• the level of the water is not high;
• the drum is not turning.
If these requirements are met, when you pause the
washing machine, the door locked light goes off and the
door can be opened.
Should it not be possible to open the door, and should it
be absolutely necessary to do so, switch the machine off
by pressing the On/Off button.
After approximately 3 minutes, you can open the door.
Pay attention to the level and temperature of the
water in the washing machine!
When you close the door and press the On/Off button
again, the washing machine will resume the programme
from the point where it had been interrupted.

15. End of programme

At the end of the programme, the washing machine
stops automatically, gives an audible signal, and
displays a blinking zero.
If you had selected the Rinse Hold option, the door is
locked ( the door locked light is on), the Start/Pause
button light goes off, the pilot light of Rinse Hold remains
lit to indicate that the water must be drained. The display
shows a flashing zero.
When the programme has been completed, a blinking
zero appears on the display and the audible signal is
given.
Press the Skip Reset button repeatedly to erase the
programme that has just been carried out. If you
omit to do this, the next time you switch the washing
machine on, the flashing zero will appear on the
display and you will hear the audible signal.
Note: when you switch the machine on, if you must
erase the previously performed programme, it is also
sufficient to press the FABRIC button and select a new
programme.
Press the On/Off button to switch the machine off. The
relevant light will go out.
Remove the laundry from the washing machine.
Check whether the drum is completely empty, by
rotating it with your hand. The purpose of this is to
prevent any items of laundry from remaining
accidentally in the drum, where they might get damaged
in a subsequent wash (e.g. by shrinking) or bleed colour
into another load of laundry.
We advise you to close the water supply tap and
disconnect the plug from the socket.
Leave the door ajar in order to air the washing machine.
12