Plumbing; Ro System - Honeywell HM600XROF1/U Installation Operation & Maintenance

RO System

(HM600XROF1/U)
Drain Points for Reject Water
Follow local codes for proper installation
Refer to additional drain requirements in steam
humidifier manual when coupling RO drain and
humidifier drain
Sump
air
gap
Standpipe
air gap
Cut 1/4" dia. tubing lines to fit your installation.
•
Ensure all cuts are evenly made with no nicks,
scratches or rough spots on the tube end.
Longer tubing lengths – nylon or copper – may
•
also be used (not provided). Ends of tubing
must be round and free of burrs and scratches
to seal properly.
Install 3/8" x 1/4" adapter elbow into blue outlet
•
port.
Verify that the plug is in place in the yellow port
•
on the base of the RO System.
Locate the drain line (1/4" dia. red tube). Install
•
one end of the line into the elbow that is pre-
installed in the red port on the RO system.
Connect the other end of the line to a drain.
Push tubing completely into applicable fitting by
•
pushing past initial resistance and then applying
light pulling force to ensure a tight fit.

PLUMBING

Cold Water
Supply
1/4 Inch
Red Tubing
Elbow Fitting
air
gap
air
gap
Laundry Floor
Tub Drain
Steam Humidifier
Shutoff
Control Valve
1/4 Inch
White Tubing
Push-in
#1
Elbow with
Flow Control
(Factory Installed)
Tubing
Tube Fully Engaged with Fitting
– To remove tube from connection, depress
collar and pull tubing.
Collar (depress to
remove tubing)
Tubing
Water tube connections to the water supply,
•
filter and steam humidifier must be checked for
leaks after installation and a short period of
operation.
5
1/4 Inch
White Tubing
3/8" x 1/4"
Adapter Elbow
Plug Fitting
(Factory Installed)
#2 #3
Collar O-Ring
M35405
FIG. 4
FIG. 5