Maintenance And Cleaning; Descaling, After Each Wash, External Cleaning; Cleaning The Dispenser Drawer, Cleaning The Drawer Recess, The Water Inlet Filters - Zanussi ZT 1082 Instruction Booklet

MAINTENANCE AND CLEANING

Before any maintenance or cleaning is carried out
you must DISCONNECT the appliance from the
electricity supply.
Descaling
The water we normally use contains lime. It is a
good idea to periodically use a water softening
powder in the machine. Do this separately from any
laundry washing, and according to the softening
powder manufacturer's instructions. This will help to
prevent the formation of lime deposits.
After each wash
Leave the door open for a while. This helps to
prevent mould and stagnant smells forming inside
the appliance. Keeping the door open after a wash
will also help to preserve the door seal.
External cleaning
Clean the exterior cabinet of the appliance with
soap and water only, and then dry thoroughly.
Cleaning the dispenser drawer
From time to time the washing powder and additive
dispenser drawer should be cleaned.
Remove the drawer by pressing the catch
downwards and by pulling it out. Flush it out under
a tap, to remove any traces of accumulated powder.
P0010
P0009
Cleaning the drawer recess
Having removed the drawer, use a small brush to
clean the recess, ensuring that all washing powder
residue is removed from the upper and lower part
of the recess.
P0038
Replace the drawer and run the rinse programme
for a few minutes without any clothes in the drum.
The water inlet filters
If your water is very hard or contains traces of lime
deposit, the water inlet filters may become clogged.
It is therefore a good idea to clean them from time
to time.
Turn off the water taps. Unscrew the water inlet
hoses. Remove and clean the filters using a hard
bristle brush. Replace the filters and tighten up the
inlet hoses.
P0041
19