Zanussi 5200 B Instructions For Use And Care Manual page 16

Removing the oven door (Fig. 11 & 12)
Warning:
It is important that the retaining discs are fully turned
and located as the hinges are under high sprung
tension.
1. Open the door completely so that it is in the
horizontal position.
2. Raise the two bars.
3. Raise the door halfway.
4. At this stage, clasp the two hinges on either side of
the door together simultaneously. The door can
then be removed by pulling on and downwards.,
maintaining the angle.
Replacing the oven door
1. Clasp the two hinges on either side of the door
simultaneously.
2. Hook the top hinge into the top slot, so that the
hook is engages with the roller.
3. Drop the lower hinge into the lower slot, so that the
notch is engaged. Drop the door down so it is in
the horizontal position.
Note
Is it important when carrying out this operation, that
both hinges be located simultaneously.
4. Turn the bars.
The door can then be closed.
Removal/replacement of the oven lamp
Important
Remember to disconnect the electricity supply before
undertaking maintenance of any kind.
Push in and unscrew the glass cap anticlockwise.
Remove the faulty bulb and replace with one that
resists heat to high temperatures (300 C). Electric
bulb 15W - 240V (50Hz), 300 C, E14.
These are available from your local Service Centre.
Fig. 11
Fig. 12
(Fig. 13)
Fig. 13
FO 0417
FO 0967
FO 0287
17