Table of Contents
Advertisement
HCD-GPX555/GPX888
CD SECTION
Note:
1. CD Block is basically constructed to operate without adjustment.
2. Use YEDS-18 disc (Part No. 3-702-101-01) unless otherwise indicat-
ed.
3. Use an oscilloscope with more than 10 MΩ impedance.
4. Clean the object lens by an applicator with neutral detergent when the
signal level is low than specifi ed value with the following checks.
5. Check the focus bias check when optical pick-up block is replaced.
FOCUS BIAS CHECK
oscilloscope
(DC range)
MB board
JL317 (RF Signal)
JL312 (Vc/Reference)
Procedure :
1. Connect the oscilloscope to JL317 (RF Signal) and JL312 (Vc/
Reference) on the MB board.
2. Press the [
STANDBY] button to turn the power on, and
?/1
press the [CD] button to select CD function.
3. Set disc (YEDS-18) and press the [u] button to playback.
4. Confi rm that oscilloscope waveform is as shown in the fi gure
below (eye pattern).
A good eye pattern means that the diamond shape () in the
center of the waveform can be clearly distinguished.
Checking Location:
-MB Board (Conductor Side)-
JL317
JL312
16
SECTION 4
ELECTRICAL CHECK
+
–
VOLT/DIV: 200 mV
TIME/DIV: 500 ns
level:
1.0 ± 0.25 Vp-p (CD)
0 dB = 1 μV
TUNER SECTION
FM AUTO STOP CHECK
set
Procedure:
1. Turn the power on.
2. Input the following signal from Signal Generator to FM an-
tenna input directly.
Carrier frequency : A = 87.5 MHz, B = 98 MHz, C = 108 MHz
Deviation
: 75 kHz
Modulation
: 1 kHz
ANT input
: 35 dBu (EMF)
Please use 75 ohm "coaxial cable" to connect SG and the
Note:
set. You cannot use video cable for checking.
Please use SG whose output impedance is 75 ohm.
3. Set to FM tuner function and scan the input FM signal with
automatic scanning.
4. Confi rm that input Frequency of A, B and C detected and
automatic scanning stops.
The stop of automatic scanning means "The station signal is
received in good condition".
signal
generator
+
75
–
Hide quick links:
Advertisement
Table of Contents
