Advertisement
Document No. 565-719
Installation Instructions
July 22, 2016
Connecting the Andover Infinet
Driver to the Andover Infinet
Network
Follow these steps to connect the Andover Infinet
Driver to the Andover Infinet network:
Figure 1. Connecting the Andover Infinet Driver to the Andover Infinet Network.
The installation is now complete.
Information in this document is based on specifications believed correct at the time of publication. The right is reserved to make changes as
design improvements are introduced. APOGEE and Insight are registered trademarks of Siemens Industry, Inc. Other product or company
names mentioned herein may be the trademarks of their respective owners. © 2016 Siemens Industry, Inc.
Siemens Industry, Inc.
Building Technologies Division
1000 Deerfield Parkway
Buffalo Grove, IL 60089-4513
USA
Tel: + 847-215-1000
1.
2.
Your feedback is important to us. If you have
comments about this document, please send
them to SBT_technical.editor@siemens.com
Disconnect the Andover Infinet network field
bus from the Andover CX Network Controller.
Connect the Andover Infinet network field bus
to the FLN1 of the RS-485 Expansion Module
on the Andover Driver per the diagram in Figure
1.
Document No. 565-719
Printed in the USA
Page 2 of 2
Advertisement
