Ip-100E Operation Panel - JUKI SC-510 Series Engineer's Manual

(4) IP-100E operation panel

Refer to the instruction manual of IP-100E/SC-510 for further information.
Re-sewing switch
Needle up/down compensating switch
Screen changeover switch
With/without reverse feed stitch
at sewing start switch
With/without reverse feed stitch
at sewing end switch
Reset switch
Teaching switch
Re-sewing switch
Needle up/down
compensating switch
Screen changeover
switch
With/without reverse
feed stitch at sewing
start switch
With/without reverse
feed stitch at sewing
end switch
Reset switch
Information switch
Material edge sensor switch
One-shot stitching switch
With/without automatic thread
trimmer switch
Thread trimming prohibiting switch
Counter value setting switch
Max. speed limitation variable resistor
Unused
This is the switch to perform needle up/down compensating stitching.
(Needle up/down compensating stitching and one stitch compensating
stitching can be changed over with function setting No.22.)
This is the switch to change over the screen.
This is the switch to turn ON/OFF automatic reverse feed stitch at sewing start.
* This switch cannot be used with the sewing machine which is not
provided with automatic reverse feed stitching device.
This is the switch to turn ON/OFF automatic reverse feed stitch at sewing end.
* This switch cannot be used with the sewing machine which is not
provided with automatic reverse feed stitching device.
This is the switch to make the value of bobbin thread counter or sewing
counter the set value.
– 6 –
Power display lamp
Smart media cover
Smart media slot
(Smart media inserting opening)
Smart media
Optional :
Part No.HX005750000