Infrared Learning - PSB ALPHA AM5 Owner's Manual

7. Bass Control: Controls the amount of bass for your listening preference. When initially activated, the bass will be set to neutral, or
half- way in the range.
8. Treble Control: Controls the amount of treble for your listening preference. When initially activated, the bass will be set to neutral, or
halfway in the range.
Note Bass & Treble: When adjusting the Bass or Treble the status light will make a single red flash to show that the midpoint of the
level has been reached. If you have reached the maximum or minimum level of the Bass or Treble, the status light will flash every time
you press the button to indicate that you have reached the limit.
9. Bluetooth Interrupt: Holding this button for 3 seconds will disconnect the current Bluetooth device. It will allow another device to
be paired or connected.

Infrared Learning

Infrared (IR) Learning enables any non-PSB remote controls learn IR control codes based on the supplied PSB PSR-1 remote control. The
functions Power ON/OFF, Volume UP/DOWN, Input Selection and Mute can be learned. With the learned codes, the configured non-PSB
remote control can be used to command or operate PSB AM5.
How To Learn IR Remote Control Codes
I. Hold MUTE button for 5 seconds to enable the IR learning feature. The Status Light on the front of the powered speaker will flash Red
and White.
II. Press the function/button, POWER ON for example, to be learned from PSB PSR-1 remote control. Status Light flashes Blue twice to
show received command, then change to solid Blue.
III. Press the corresponding button on the non-PSB remote control where POWER ON will be learned. Status Light flashes Green twice to
indicate that function/command has been learned.
IV. Repeat Step 2-3 to learn Power OFF, Volume UP/DOWN, Input Selection and Mute.
Note: IR learning setup times out after 10 seconds of inactivity.