For The Installer; Installation; Electrical Connections; Connecting To The Mains - Zanussi ZM 24ST Instruction Manual

ZM 24ST
1. Remove any promotion label from the door.
2. This oven can be used as a free standing
oven or built-in, into a kitchen cabinet
using kit number BF246, which is ordered
separately. To install the oven in a kitchen
cabinet follow the instructions supplied
with the building-in kit.
The oven should be installed on a flat,
level surface. The surface must be strong
enough to safely bear the weight (18 kg)
of the oven, and the contents. To avoid the
possibility of causing vibration or noise
the oven must be in a stable position.
3. Keep the oven away from heat and water.
Exposure to heat and water can lower
oven efficiency and lead to malfunctio-
ning, so be sure to install the oven away
from heat and water sources.
4. If using the appliance as a free-standing
appliance do not block air vents on the
top and the sides of the cabinet and also
do not place any articles on the top of the
oven. A gap all around the oven is neces
sary : 140 mm above the oven and any
objects, 50 mm on the sides and 100 mm
behind the oven. If air vents are blocked
during operation the oven may overheat,
and this may lead to malfunctioning. Hot
air escapes from the vents, so be sure
not to obstruct them or let curtains come
between the oven and the rear wall.
5. Place the oven as far away from radios
and TVs as possible. This oven does con-
form to EEC requirements of radio interfe-
rence suppression, but some interference
may occur if it is placed too close to a
radio or TV, so keep them as far apart as
possible.

Electrical connections

THIS APPLIANCE MUST BE EARTHED.
!
The manufacturer declines any
liability should this safety measu-
re not be observed.

For the installer

Connecting to the mains

The oven is delivered with the power cord
and a plug for 240 V, 50Hz, earthed socket
outlet.
Earth protection minimizes the risks should
a shortcircuit occur. Check to ensure the vol-
tage of the oven matches the supply.
N.B. If the oven is connected to the socket
via an extension cord, make sure the cord is
earthed.
This appliance must not be used on a
!
non-earth protected power supply.
Contact an electrician if you are uncer-
tain regarding electricial connection of
the oven or provision of earth protec-
tion of the supply.
This appliance must be earthed. If this
appliance is fitted with a non-rewirable
plug for which your socket is unsuitab-
le, the plug should be cut off and the
appropriate plug fitted. If it is necessa-
ry to change the fuse in a nonrewirab-
le plug, the fuse cover must be refitted.
If the fuse cover is lost or damaged,
the plug must not be used until a repla-
cement is obtained.
26
UK