Working In A Ti-Nspire™ Cx Premium Teacher Software Classroom; Using Wireless Communication Hardware - Texas Instruments TI-Nspire CX II Series Handhelds Manualbook

Working in a TI-Nspire™ CX Premium Teacher Software
Classroom
If you are in a classroom where TI-Nspire™ CX Premium Teacher Software is used, you
will need to log in to class to communicate with the teacher's computer. The teacher
can communicate with your handheld in the following ways:
• Send files
• Collect files
• Delete files
• Send Quick Polls and receive Quick Poll responses
The teacher can also pause and restart your handheld. When class is paused, you will
receive a message on your handheld. You cannot use your handheld until the teacher
releases the handheld from pause mode.

Using Wireless Communication Hardware

Teachers using TI-Nspire™ CX Premium Teacher Software in the classroom can attach
wireless cradles and/or network adapters to students' TI-Nspire™ CX handhelds. Those
handhelds can then link wirelessly to an access point attached to the teacher's
computer.
You can attach any the following devices to TI-Nspire™ CX handhelds:
• TI-Nspire™ CX Wireless Network Adapter - v2 (2.4 GHz or 5.0 GHz band)
• TI-Nspire™ Wireless Network Adapter (2.4 GHz)
Attaching a Wireless Adapter to a CX Handheld
The battery in the handheld powers the wireless adapter.
Note:
1. Position the wireless adapter on top of the handheld so the connector on the
adapter lines up with the connector on top of the handheld.
Wireless network adapter (school-owned)
Connector
2. Slide the adapter into position, making sure the guides on the sides of the adapter
slide into the grooves on the sides of the handheld.
54 Working in a TI-Nspire™ CX Premium Teacher Software Classroom
Guides for aligning
with handheld