Servicing - Zanussi ZT 415 Instruction Booklet

SERVICING

Certain problems are often due to lack of simple
maintenance or oversights and can be solved easily
without having to call out an engineer.
If the machine will not start
The door has not been properly closed.
The plug is not properly inserted in the power socket.
There is no current at the socket. Check the fuse.
This dishwasher may display a fault code in the pilot
lights of the programmes which will assist you in
identifying the fault. If the ON/OFF indicator light is
illuminated and one of the programme's indicator
light is flashing please carry out the following
checks.
If the pilot light of the RINSE & HOLD
programme is flashing
The dishwasher will not fill with water
The water tap is closed.
Open the tap. Switch off the dishwasher; switch it
back on and start the wash programme. If the alarm
reappears, call the Service Centre.
Mains water supply cut off
Wait for the supply to be restored.
Switch off the dishwasher; switch it back on and
start the wash programme. If the alarm reappears,
call the Service Centre.
Water feed pipe bent or squashed
Reposition the pipe (see instructions for connection
to the water supply).
Switch off the dishwasher; switch it back on and
start the wash programme. If the alarm reappears,
call the Service Centre.
Filter in the water feed pipe clogged
Close the water tap, unscrew the water feed pipe
and thoroughly clean the filter. Screw the pipe back
on and open the water tap.
Switch off the dishwasher; switch it back on and
start the wash programme. If the alarm reappears,
call the Service Centre.
If the indicator light of the INTENSIVE
programme is flashing
The filters are clogged
Clean the filters (see MAINTENANCE section).
Check outlet hose is not blocked.
Check dishes are correctly loaded.
Switch off the dishwasher; switch it back on and
start the wash programme. If the alarm reappears,
call the Service Centre.
If the indicator light of the QUICK
programme is flashing
The dishwasher does not empty out water
The discharge pipe is bent.
Eliminate the bend (see instructions for connection
to the drain).
Switch off the dishwasher; switch it back on and
start the wash programme. If the alarm reappears,
call the Service Centre.
The sink drain is blocked
Unblock the sink drain pipe.
Switch off the dishwasher; switch it back on and
start the programme. If the alarm reappears, call the
Service Centre.
The discharge pipe extension is not correct.
Carefully follow the instructions for "Connection to
the drain".
Switch off the dishwasher; switch it back on and
start the wash programme. If the alarm reappears,
call the Service Centre.
The wall drain connection has no breather.
Consult a qualified engineer.
If the pilot light of the NORMAL OR
ECONOMY programme is flashing
General
Switch off the dishwasher; switch it back on and
start the wash programme. If the alarm reappears,
call the Service Centre.
The dishes are not clean (poor wash)
The baskets are too full.
The dishes have not been arranged properly.
The spray arms do not rotate.
The spray arms holes are clogged.
The filters are clogged.
Not enough detergent has been used or it is
unsuitable.
The detergent is old or has gone hard.
The salt container cap is not properly closed.
The washing programme selected is too gentle.
Visible lime deposits or white film on the dishes
There is no salt or the softener has not been adjusted
to the hardness of the water.
The rinse aid has run out or too little is being used.
The machine is noisy
The dishes are rattling against each other.
PRA03GB
14