Rinse Aid - Zanussi Electrolux ZSF 6120 Instruction Book

Rinse aid

Rinse aid is automatically added during the last rinse, ensuring
thorough rinsing, and spot and streak free drying.
The dispenser, which is positioned inside the door, holds about
110 ml of rinse aid, which is sufficient for 16 - 40 dishwashing
programmes, depending upon the dosage setting.
Filling with rinse aid
1. Open the container by pressing the release button (A).
2. Add the rinse aid until the container is completely full. The
maximum level for filling is indicated by "max".
BR07
Ensure that the lid is closed after every refill.
Clean up any rinse aid spilt during filling with an
absorbent cloth to avoid excess foaming during the next
wash.
Only use branded rinse aid for dishwashers. Never fill the
rinse aid dispenser with any other substances (e.g.
dishwasher cleaning agent, liquid detergent). This would
damage the appliance.
Adjusting the dose
According to the finish and drying results obtained, adjust the
dose of rinse aid by means of the 6 position selector (position
1 minimum dosage, position 6 maximum dosage).
The dose is factory set in
position 4.
Increase the dose if there are
drops of water or lime spots
on the dishes after washing.
Reduce it if there are sticky
whitish streaks on the dishes
or a bluish film on glassware
or knife blades.
Top up the rinse aid when the indicator light on the control
panel illuminates.
BR14
BR09
If you are using dishwasher detergent that already contains
rinse aid, it is necessary to deactivate the dosage of rinse
aid, in order to avoid a double dosage.
Deactivation/activation of the dosage of
rinse aid
(The dishwasher must be switched off)
Factory setting: dosage of rinse aid activated
When the dosage of rinse aid has been deactivated, the
rinse aid indicator light on the control panel is
automatically deactivated.
1. Press the On/Off push button. The On/Off indicator light
illuminates (setting mode).
If a programme push button indicator light is on, this means
that a washing programme has been set. The programme
must be cancelled: press simultaneously the function push
buttons 2 and 3 for about 2 seconds.
All the indicator lights will turn off (except for the On/Off
indicator light and eventually salt and rinse aid indicator
lights) indicating that the setted programme has been
cancelled and the machine is now in setting mode.
2. Press simultaneously function push buttons 2 and 3, until
the indicator lights of the function push buttons 1, 2 and 3
start flashing.
3. Press the function push button 2, the indicator lights of
function push buttons 1 and 3 turn off while the indicator
light of the function push button 2 goes on flashing, at the
same time the indicator light End of cycle illuminates
indicating that the dosage of rinse aid is active.
4. To deactivate the inflow of rinse aid, press the function push
button 2 again, the indicator light End of cycle turns off,
indicating that the dosage of rinse aid has been deactivated.
5. To memorise the operation, switch off the dishwasher by
pressing the On/Off push button or wait about 60 seconds
after which the dishwasher will automatically return to
setting mode.
To activate the dosage of rinse aid follow the above
instructions until the indicator light End of cycle illuminates.
7