Zanussi ZDT 312 User Manual page 20

Fault code and malfunction
• 1 intermittent audible signal
• continuous flashing of the light of the running
programme
• 1 flash of the "end of programme " indicator light
The dishwasher does not fill with water.
• 2 intermittent audible signals
• continuous flashing of the light of the running
programme
• 2 flashes of the "end of programme " indicator
light
The dishwasher will not drain.
• 3 intermittent audible signals
• continuous flashing of the light of the running
programme
• 3 flashes of the "end of programme" indicator
light
Anti-flood device is activated
The programme does not start.
Once these checks have been carried out;
switch on the dishwasher. The programme will
continue from the point at which it was inter-
rupted.
If the malfunction or fault code reappears con-
tact the Service Force Centre.
20
Possible cause and solution
• The water tap is blocked or furred with limescale.
Clean the water tap.
• The water tap is turned off.
Turn the water tap on.
• The filter (where present) in the threaded hose fitting
at the water inlet valve is blocked.
Clean the filter in the threaded hose fitting.
• The water inlet hose has not been correctly laid or
it is bent or squashed.
Check the water inlet hose connection.
• The sink spigot is blocked.
Clean out the sink spigot.
• The water drain hose has not been correctly laid or
it is bent or squashed.
Check the water drain hose connection.
Close the water tap and contact your local Service
Force Centre.
• The dishwasher door has not been properly closed.
Close the door.
• The main plug is not plugged in.
Insert the mains plug.
• The fuse has blown in the household fuse box.
Replace the fuse.
For other fault codes not described in the above
chart, please contact your Service Force Cen-
tre.