California Proposition 65 Warnings - Smith Little Torch Owner's Manual

CYLINDERS can explode if damaged.
Compressed gas cylinders contain gas under high pressure. If
damaged, a cylinder can explode. Since gas cylinders are normally part
of the welding or cutting process, be sure to treat them carefully.
D
Protect compressed gas cylinders from excessive heat, mechani-
cal shocks, physical damage, slag, open flames, and sparks.
D
Install cylinders in an upright position by securing to a stationary
support or cylinder rack to prevent falling or tipping. Do not lay acet-
ylene cylinders on their sides or acetone will flow out of the cylinder
and damage the equipment.
D
Keep cylinders away from any arc welding, cutting, or other electri-
cal circuits.
D
Never drape a welding or cutting torch over a gas cylinder.
D
Never weld or cut on a pressurized cylinder − explosion will result.
D
Use only correct compressed gas cylinders, regulators, hoses, and
fittings designed for the specific application; maintain them and as-
sociated parts in good condition. Do not use compressed gas cylin-
der unless an approved gas regulator is attached to the gas valve.
D
Turn face away from valve outlet when opening cylinder valve. Do
not stand in front of or behind the regulator when opening the valve.
D
Keep protective cap in place over valve except when cylinder is in
use or connected for use.
D
Use the right equipment, correct procedures, and sufficient num-
ber of persons to lift and move cylinders.
D
Store compressed gas and oxygen cylinders in separate locations.
D
Store empty cylinders with valves closed and caps in place.
D
Do not modify or repair cylinders or valves. Store leaking acetylene
cylinders outdoors in a safe area. Identify leaking cylinders and re-
turn them to the supplier.
D
Dispose of used disposable cylinders according to the manufactur-
er's recommendations. Do not throw cylinders in fire.
D
Follow instructions provided by the gas supplier and on com-
pressed gas cylinders, associated equipment, and in Compressed
Gas Association (CGA) publication P-1 listed in Safety Standards.
FLYING METAL or DIRT can injure eyes.
S
Welding, cutting, chipping, wire brushing, and grinding cause
sparks and flying metal.
S
Wear welding goggles, or wear welding helmet/welding face-
shield over approved goggles/safety glasses with side shields.

1-3. California Proposition 65 Warnings

Welding or cutting equipment produces fumes or gases
which contain chemicals known to the State of California to
cause birth defects and, in some cases, cancer. (California
Health & Safety Code Section 25249.5 et seq.)
This product contains chemicals, including lead, known to
the state of California to cause cancer, birth defects, or other
reproductive harm. Wash hands after use.
OM-263 357 Page 5