Husqvarna 325iLK Operator's Manual page 8

servicing dealer, ask him for the address of
your nearest service agent.
To use the user interface
1. To operate the user interface, the power lever (A) is
pushed into three different positions.
B
C
D
a) Stop position (B), the product is off.
b) Start position (C), the product is on.
c) SavE position (D), the SavE mode is on.
To do a check of the power trigger lockout
The power trigger lockout is designed to prevent
accidental operation. When you push the power trigger
lockout forward (1) and then press the power trigger
lockout against the handle (2), the power trigger (3) is
released. When you release the handle, the power
trigger and the power trigger lockout both move back to
their original positions. This movement is operated by
three independent springs.
3
1. Make sure that the power trigger is locked when the
power trigger lockout is in its original position.
8
A
2
1
2. Press the power trigger and make sure it returns to
its original position when you release it.
3. Make sure that the power trigger and the power
trigger lockout moves freely and that the return
spring operates correctly.
4. Start the product, refer to
page 12 .
5. Apply full speed.
6. Release the power trigger and make sure that the
cutting attachment stops and remains still.
Safety instructions for assembly
WARNING: Read this power unit manual
together with approved accessory manual.
• Remove the battery from the product before you
assemble the product.
• Use approved protective gloves.
• A defective or incorrect guard can cause injury. Do
not use a cutting attachment that does not have an
approved guard attached.
• Make sure that you assemble the cover and shaft
correct before you start the product.
• If a harness is supplied with the attachment, the
harness must be correctly attached to the product.
The harness makes operation safe and prevents
injury to the operator or other persons.
Safety instructions for maintenance
WARNING: Read the warning instructions
that follow before you do maintenance on
the product.
• Remove the battery before you do maintenance,
other checks or assemble the product.
• The operator must only do the maintenance and
servicing shown in this operator's manual. Turn to
your servicing dealer for maintenance and servicing
of a larger extension.
• Do not clean the battery or the battery charger with
water. Strong detergent can cause damage to the
plastic.
2
1
To start the product on
1386 - 002 - 04.12.2019