English Limited Warranty Dear customer, Welcome to B&W. This product has been designed and manufactured to the highest quality standards. However, if something does go wrong with this product, B&W Loudspeakers and its national distributors warrant free of charge labour (exclusion may apply) and replacement parts in any country served by an official B&W distributor.
Page 5
Contact your dealer if there are any missing items. POSITIONING Stray magnetic fields If you are using speakers in a home theatre set-up and you are using a CRT screen (a traditional tube television or back projector), make sure the picture is not going to be distorted by stray magnetic fields from the drive unit motor systems.
Page 6
(figure 18) f Continue to section 3. MOUNTING Model f Go to 800D/801D/802D HTM1D 803D/803S/804S 805S/HTM2D/HTM3S/HTM4S 3.5 SCMS DS8S 800D/801D/802D On delivery, the speakers are fitted with roller glides to aid movement.
Screw in the feet with locking ring attached, with either the spikes or rubber tips outermost, according to the type of floor surface. Leave the tips of the feet protruding beyond the inner packing pieces for clearance when the speaker is upright.
Page 8
CONNECTIONS All connections should be made with the equipment switched off. The terminals accept a variety of cable terminations to suit most applications – 4mm banana plugs, 6mm and 8mm (1/4 in and 5/16 in) spades, or bare wires up to 6mm (1/4 in) diameter. Important safety notice In certain countries, notably those in Europe, the use of 4mm banana...
For these reasons, we recommend that you leave tweeter grilles in place. 800D, 801D, 802D, HTM1D only If you use these systems without the midrange grille, replace the plastic centre plug of the midrange drive unit with the solid aluminium plug in the accessory pack.
800D, 801D, 802D, HTM1D only To replace the midrange grille, locate the central peg in the hole at the tip of the plastic centre plug fitted to the drive unit.