Related Manuals for Zanussi GAS COOKER ZCG 640
Summary of Contents for Zanussi GAS COOKER ZCG 640
- Page 1 COOKER ZCG 640 ZCG 641 INSTRUCTION BOOKLET Please read this instruction booklet before using the appliance...
-
Page 2: Important Safety Information
Important Safety Information You MUST read these warnings carefully before installing or using the hob. If you need assistance, contact our Customer Care Department on 08705 727727 Installation • This appliance must be installed and serviced by a competent person as stated in the Gas Safety ( Installation and Use) Regulations Current Editions and the IEE Wiring Regulations. -
Page 3: Table Of Contents
Contents For the User Important Safety Information Control Panel The Gas Hob Controls The Gas Oven and Electric Grill Control Before the First Use of the Cooker Using the Oven The Minute Minder Using the Gas oven Gas Oven Cooking Chart Grilling Maintenance and Cleaning Cleaning the Oven... -
Page 4: Control Panel
Control Panel 1. Electric ignition button 2. Oven Light button 3. Back left burner control knob (semi-rapid) 4. Front left burner control knob (rapid) 5. Front right burner control knob (auxiliary) 6. Back right burner control knob (semi-rapid) 7. Gas Oven and Electric Grill control knob 8. -
Page 5: The Gas Hob Controls
The Gas Hob Controls To light a burner: Push the electric ignition button which is marked with a little spark ( At the same time push in and turn the relevant control knob anticlockwise to maximum position. Then adjust the flame as required. If the burner does not ignite, turn the control knob to zero, and try again. -
Page 6: Before The First Use Of The Cooker
The Minute Minder The minute minder will mark the end of a timed period with an acoustic alarm. The maximum timing is 60 minutes. Turn the Minute Minder knob clockwise to the maximum time position, then turn it back to the required time. The Minute minder will not affect in any way the oven operation, if it is in use. -
Page 7: Using The Gas Oven
Hints and Tips Condensation and Steam When food is heated it produces steam in the same way as a boiling kettle. The oven vents allow some of this steam to escape. However, always stand back from the oven when opening the oven door to allow any build up of steam or heat to release. -
Page 8: Gas Oven Cooking Chart
Gas Oven Cooking Chart This chart is intended as a guide only. It may be necessary to increase or decrease the temperature to suit your individual requirements. Only experience will enable you to determine the correct setting for your personal requirements. TEMPERATURES FOOD PUDDINGS... -
Page 9: Grilling
Grilling Grilling must be carried out with the oven door closed. The grill pan handles must be removed from the pan. How to Use the Grill 1. Turn the oven control function knob to The grill pilot light will come on. 2. -
Page 10: Maintenance And Cleaning
Maintenance and Cleaning Before any maintenance or cleaning can be carried out, you must DISCONNECT the cooker from the electricity supply. This appliance cannot be cleaned with steam or with a steam cleaning machine. The Hob Top The hob is best cleaned whilst it is still warm, as spillage can be removed more easily than if it is left to cool. -
Page 11: Oven Cavity
Oven Cavity The enamelled oven cavity is best cleaned whilst the oven is still warm. Wipe the oven over with a soft cloth soaked in warm soapy water after each use. From time to time it will be necessary to do a more thorough cleaning, using a proprietary oven cleaner. -
Page 12: Something Not Working
For the address of your local Service Force Centre and further information about Service Force, please visit the website at www.serviceforce.co.uk For Customer Service in the Republic of Ireland please contact us at the address below: Zanussi-Electrolux Electrolux Group (Irl) Ltd Long Mile Road Dublin 12 Republic of Ireland Tel: +353 (0) 1 4090 751 Email: service.eid@electrolux.ie... -
Page 13: Customer Care
* calls to this number may be recorded for training purposes. Guarantee Conditions Zanussi guarantee conditions We, Zanussi, undertake that if, within 12 months of the date of the purchase, this Zanussi appliance or any part thereof is proved to be defective by any reason only of... -
Page 14: Important Safety Requirements
Instructions for the Installer Technical Data Appliance Class 2 sub class 1 and Class 1 APPLIANCE CATEGORY: APPLIANCE GAS SUPPLY: Natural Gas G20 20mbar Dimensions Height Depth Width Oven Capacity BURNER TYPE OF CHARACTERISTICS POSITION NOMINAL THERMAL POWER (kW) NATURAL VALUE = Hs 37.78 MJ/m NOMINAL FLOW... -
Page 15: Installation
Location of the appliance This appliance must not be installed in a bed-sitting room of volume less than 20m³ or in a bathroom, shower room or garage. It is essential that the appliance is positioned as stated below (see fig.1) i.e. shelves, wall cabinets and cooker hoods must be fitted a minimum of 787mm directly above the top of the hotplate and 400mm above the hotplate when fitted in line with the... -
Page 16: Fitting The Stability Bracket
FO 0179 Fig. 2 Fitting the Stability Bracket (Not supplied) If the cooker has to be installed with a flexible supply pipe, it is necessary that a stability device is fitted. (See "Important Safety Requirements"). The stability bracket is to be fitted by the installer and these instructions should be read in conjunction with the leaflet packed with the stability bracket. -
Page 17: Electrical Connections
Electrical connections Any electrical work required to install this cooker should be carried out by a qualified electrician or competent person, in accordance with the current regulations. THIS COOKER MUST BE EARTHED. The manufacturer declines any liability should these safety measures not be observed. -
Page 18: Commissioning
Commissioning When the hob has been fully installed it will be necessary to check the minimum flame setting. To do this, follow the procedure below. Turn the gas tap to the MAX position and ignite. Set the gas tap to the MIN flame position then turn the control knob from MIN to MAX several times. - Page 19 Replacement of gas oven burner nozzle To replace the gas oven nozzle, follow this procedure: 1. Remove the bottom plate of the oven cavity (“A”); 2. Undo the two fixing screws (“C”) which keep the oven gas burner in place 3.
- Page 20 CUSTOMER CARE Zanussi-Electrolux Cornwall House 55-77 High Street Slough Berkshire SL1 1DZ 08705 727727 (*) © Electrolux plc 2004 From the Electrolux Group. The world’s No.1 choice. The Electrolux Group is the world’s largest producer of powered appliances for kitchen, cleaning and outdoor use. More than 55 million Electrolux Group products (such as refrigerators, cookers, washing machines, vacuum cleaners, chain saws and lawn mowers) are sold each year to a value of approx.