Replying To The Sender Of The Checked Message Or Image Data; Forwarding The Checked Message Or Image Data - Yaesu FTM-300DR Instruction Manual

Replying to the Sender of the Checked Message or Image Data

After checking the message or image data, you may reply to the sender.
1. Select the information (MESSAGE or PICT) to review according to steps 1 to 4 of
"Checking Received Messages and Images" (page 7).
Displays the selected data.
2. Press the [F(SETUP)] key, then rotate the DIAL knob to select [REPLY], then press
the DIAL knob.
The call sign of the station that sent MESSAGE or PICT to the destination is set au-
tomatically.
3. Rotate the DIAL knob to select [EDIT], thenpress the DIAL knob.
Displays the message entry screen.
4. Follow steps 1 to 7 in "Creating and sending a new message" on page 9 to
display the message entry screen.
Displays the entire message.
5. Press the [F(SETUP)] key, then rotate the DIAL knob to select [SEND], then press
the DIAL knob.
Sends the reply message to the sender of the MESSAGE/PICT data.

Forwarding the Checked Message or Image Data

After reviewing the message or image data, you may forward the data to other members.
1. Select the information (MESSAGE or PICT) to check according to steps 1 to 4 of
"Checking Received Messages and Images" (page 7).
Displays the selected data.
2. Press the [F(SETUP)] key, then rotate the DIAL knob to select [FWD], then press the
DIAL knob.
3. Rotate the DIAL knob to select [ALL], the press the DIAL knob.
Messages and images will be transferred.
• To send the message to a specific member that is within communication range,
touch the member callsign.
• Messages cannot be sent to members outside of communication range.
• The address designation "to:" is merely for displaying "ALL" or the call sign of a specific
station. In other words, even if you specify a call sign for "to:" to send a message,
other stations operating GM on the same frequency can also read the message if they
are within the communication range.
12