Optional Cables; Anyfeeder Connections; Electrical Connectors On Interface Panel - Omron AnyFeeder Series Integration Manual

Chapter 4: System Installation
Step
10 Connect camera and cable to SmartVision MX. Use USB PoE 1 on MX.
11 Connect 24 VDC Servo cable to DC Input on AnyFeeder interface panel.
12 Connect an 8 mm OD air line to the pneumatic connector SX240, SX340.
13 Connnect IEEE 1394 cable between SmartController EX and eAIB SmartServo.

Optional Cables

NOTE: The following cables are not covered in the steps in the preceding table.
Part Description
XIO Breakout Cable, 12 inputs/
8 outputs, 5 M
Y Cable, for XSYS cable connections
to dual robots
eAIB XBELT IO Adapter Cable
The XIO Breakout cable is for using the I/O on the eAIB.
The Y cable attaches at the SmartController EX XSYS connector, and splits it into two XSYS
connectors. This is part number 00411-000. See the Dual Robot Configuration Guide.
The optional eAIB XBELT IO Adapter cable splits the eAIB XBELTIO port into a belt encoder
lead, an Intelligent Force Sensor or IO Blox lead, and an RS-232 lead. If the system has a
SmartController EX, this is only needed for Intelligent Force Sensing.

4.3 AnyFeeder Connections

Electrical Connectors on Interface Panel

Connection
Serial connection
to SmartVision MX
Servo Motor Cable
to 24 VDC supply
Figure 4-3. Electrical Connectors on AnyFeeder Interface Panel
AnyFeeder Integration Guide - Page 24
Notes
Available as option
Available as option with
SmartController EX
Available as option
Part
T
U, V
X
W