RIDGID R45171 Operator's Manual page 17

ASSEMBLY
MOUNTING THE TABLE SAW TO THE LEG
STAND
See Figure 10.
WARNING:
Do not lift the saw without help. The saw weighs
approximately 55 lbs. Hold it close to your body.
Keep your knees bent and lift with your legs, not
your back. Ignoring these precautions can result
in back injury.
 Place the stand on level ground and open to its fully
extended position.
 Position the table saw onto the stand so that the tabs on
the stand are positioned just outside the saw feet and the
holes in the feet align with the holes in the saw stand.
NOTE: Make sure the table saw feet are flush against the
stand and that all the stand legs are touching the ground.
SOCKET HEAD HEX SCREW
TAB
(M6 X 25 mm)
WASHER
(ID6.5 X OD16
X 1.5t)
(M6)
Fig. 10
 Insert M6 x 25 mm socket head hex screws through the
holes in the table saw and into the holes in the stand.
Install washers (ID6.5 x OD16 x 1.5t) and secure with M6
lock nuts that are hand tightened.
 Tighten all hardware with a wrench and hex key. Use a
wrench to hold the hex nut and turn the hex key to tighten
the screws.
TO STORE THE TABLE SAW ACCESSORIES
See Figures 11 - 12.
The table saw has two convenient storage areas (one on
either side of the saw cabinet) specifically designed for the
saw's accessories. These accessories must be securely
stored prior to closing the leg stand and moving the saw.
NUT
WRENCHES
PUSH STICK
17 − English
BLADE
MITER
GAUGE
Fig. 11
Fig. 12