Table of Contents
Advertisement
Shear Bolts
Washer
Hex Nut
Figure 15
•
Remove the six carriage bolts (three per side),
belleville washers and hex nuts which attach slide
shoes to the snow thrower on two sides. See Figure 8.
•
Reassemble new slide shoes with the hardware
removed earlier (cupped side of belleville washer
against the slide shoes). Make certain the slide
shoes are adjusted to be level.
•
To remove the shave plate, remove slide shoe as
well as the carriage bolts, belleville washers and
hex nuts which attach shave plate to the snow
thrower housing. For location of shave plate and
carriage bolts, see Figure 15.
•
Reassemble the new shave plate, making sure
heads of carriage bolts are to the inside of the
housing.
•
Reinstall the skid shoes and tighten securely.
Replacing Belts
To remove and replace either the auger belt or the drive
belt, follow the steps below and then proceed to the
specific steps listed under respective sub-headings.
•
Disconnect the chute crank assembly at the
discharge chute end by removing the hairpin clip
and the two flat washers.
•
Remove the plastic belt cover, located near the
engine, by removing the three self-tapping screws
and flat washers that secure it. See Figure 16.
•
Remove the large shoulder bolt and washer on the
left hand side of the engine pulley. See Figure 16.
Carriage Bolt
Shave Plate
Flat
Hairpin
Washers
Clip
Engine Pulley
Shoulder Bolt
Auger Belt
•
Remove the cotter pin and washer from the ferrule
in order to disconnect the auger idler rod from the
brake bracket assembly. See Figure 17.
•
Slip the auger control belt (the front belt) off the
engine pulley.
Engine
Pulley
Auger Idler
Rod
Ferrule
Brake Bracket
Assembly
Z Fitting
14
Belt Cover Bolts(3)
Belt Cover
Upper Bolt
Shoulder Bolt
(remove)
(do not remove)
Figure 16
Auger Control
Belt
Cable Roller
Guide
Figure 17
Hide quick links:
Advertisement
Table of Contents
