Setting The Manufacturer Code - Yamaha RX-V2200 Owner's Manual

Setting the Manufacturer Code

You can control other components by setting a
manufacturer code. A code can be set up in each
component control area.
The following table shows factory-set component
(Library: component category) and the manufacturer code
for each area. If you are to make a setting for different
component from the factory setting, change the library as
described in step 3 on right.
Input area Component category
(Library)
A
B SATELLITE TUNER
PHONO
TUNER TUNER
CD
V-AUX
CBL/SAT CABLE
MD/TAPE
CD-R CD-R
D-TV/LD
VCR 1
VCR 2/DVR
DVD DVD
1
Press an input selector button, Å or ı to
select the source component you want to set
up.
A B
PHONO
V-AUX TUNER MD/TAPE CD-R CD
D-TV/LD CBL/SAT VCR 1 VCR2/DVR DVD
2
Press and hold LEARN for about 3 seconds
by using a ballpoint pen or similar object.
"SETUP" and the selected component name appear
alternately in the display window.
LEARN
Notes
• Press LEARN for at least 3 seconds, otherwise the learning
process is started.
• If you do not press any button within 30 seconds during step 3,
the setup process is canceled. If this happens, start over from
step 2.
Manufacturer
LD YAMAHA
–
TV –
YAMAHA
CD YAMAHA
VCR –
–
MD YAMAHA
YAMAHA
TV –
VCR –
VCR –
YAMAHA
3
Press k / n to select the name of your
component's manufacturer.
You will find the names of most worldwide audio-
video manufacturers in alphabetical order in the
display window.
ENTER
If you want to change a library (component
category), press l / h. You can set a
different component from the input selector
name.
Library choices: DVD, LD, CD, CD-R, MD, TAPE,
TUNER, AMP, TV, CABLE, DBS, SAT, VCR
Note
If the manufacturer of your component has more than one codes,
try each of them until you find the correct one as checking if it
works following step 4.
4
Press one of the buttons shaded below to
check if it works for the component being
set. If it does, the manufacturer code setting
has been correctly made.
SOURCE
DISPLAY
SELECT
SEARCH
POWER REC
y
• If you continuously want to set up another code for another
component, press ENTER and repeat steps 1, 3 and 4.
5
Press LEARN again to exit from the setup
mode.
LEARN
Notes
• If you have already programmed a remote control function for
a button, the function by learning or macro programming takes
priority over the setup manufacturer code's function.
• "ERROR" appears in the display window under the following
circumstances:
– when pressing a button other than the cursor and ENTER;
– when pressing more than one button at once; or
– when MACRO ON/OFF, 10KEY/DSP or PARAMETER/SET
MENU is switched to another position.
REMOTE CONTROL FEATURES
6CH INPUT
TITLE
ENTER
MENU SOUND
– +
CHAPTER
STOP PAUSE PLAY
43