Download Print this page
Coleman Montana Setup Instructions

Coleman Montana Setup Instructions

Modified dome with half fly

Advertisement

Available languages

Available languages

Quick Links

Before you begin
• Read all instructions before set up.
• Select a level site clear of rocks, branches, and
other hard or sharp objects, to install your tent.
WARNING: Keep clear of overhead power lines.
• Do not set up your tent under trees because of
potential lightning strikes or falling tree limbs in
inclement weather.
• NOTICE: Secure product with all ground
stakes, guylines and velcro straps for optimal
performance and to prevent property damage or
personal injury.
• For best results in windy conditions, position
narrow end of tent into the wind.
• Enlist the help of at least one other person to
assist you when it is time to assemble the tent.
How to Store
1. All poles and stakes must be placed in the
storage bag to prevent damage to the fabric
items placed in the carry case.
2. Make sure tent is clean and dry before placing
in carry case.
3. Remove rainfly, spread out on floor of tent, then
unzip door & vents before taking tent down for
storage.
4. Neatly fold tent to width of pole storage bag,
then place pole storage bag on tent, roll tightly,
and place in carry case.
5. Store in a clean, dry area.
How to get repair kit number
Diameter
6.0 mm
5010000544
Pole Repair Kit
Pole List
A
. Main Body Pole(black) . ............x 2
B
. Side Body Pole(gray) ...............x 2
C
. Short Door Pole (black).................x1
D
. Long Door Pole (black).................x1
E
. Vestibule Pole (black)..................x1
Front view of complete tent
TENT SETUP INSTRUCTIONS
Montana Modified Dome, with half fly
(The product may look different from yours. It is for illustration purpose only.)
Things You Should Know
• Under certain conditions (cold weather, high humidity, etc.) condensation will form
on the inside of your tent. Condensation is caused by water vapor from your breath,
perspiration, or any wet clothing inside the tent. It is NOT LEAKAGE through the
tent fabric. It can be minimized by removing wet clothing from your tent and by
providing good ventilation through the tent.
• Tree limbs, tree sap, bird droppings, or moisture steadily dripping off tree limbs can
cause damage to the tent fabric and its coating resulting in leaks or loss of flame-
resistant properties.
• Never store tent, even for a short period of time, without drying it thoroughly and
brushing off caked dirt. Do not pack stakes or poles inside your tent. Use a separate
storage bag.
• Stakes should be removed by pulling on the stake itself. NEVER PULL ON THE TENT
TO REMOVE STAKES AS THIS COULD RESULT IN PROPERTY DAMAGE OR PERSONAL
INJURY.
• Tent poles should not be left telescoped together during storage.
• Do not leave your tent set-up for weeks at a time. Be aware that exposure to
ultraviolet rays from the sun can seriously damage material and/or cause it to
become discolored.
This tent meets the flammability requirements of CPAI-84. The fabric may burn if left in
continuous contact with any flame source. The application of any foreign substance to
the tent fabric may render the flame-resistant properties ineffective. (For u.S.A. Only)
This tent is made of flame-resistant fabric. It is not fireproof. The fabric will burn if left
in continuous contact with a flame source. The application of any foreign substance to
the tent fabric may render the flame-resistant properties ineffective. (For Canada Only)
6.9/7.0 mm
6.3 mm
5010000543
5010000542
E
WARNING: KEEP ALL FLAmE ANd HEAT SOuRCES
AWAY FROm THIS TENT FABRIC.
Note: To get the repair kit number, you can compare the end of the
pole with the circles on below table, or measure diameter of the
pole end.
7.9 mm
8.5 mm
5010000541
5010000569
9.5 mm
11.0 mm
5010000540
5010000539
A
B
C
Tent without rainfly
Rear view of complete tent
12.7 mm
5010000538
A
B
D

Advertisement

loading

Summary of Contents for Coleman Montana

  • Page 1 TENT SETUP INSTRUCTIONS Montana Modified Dome, with half fly (The product may look different from yours. It is for illustration purpose only.) Before you begin Things You Should Know • Read all instructions before set up. • Under certain conditions (cold weather, high humidity, etc.) condensation will form • Select a level site clear of rocks, branches, and on the inside of your tent. Condensation is caused by water vapor from your breath, other hard or sharp objects, to install your tent. perspiration, or any wet clothing inside the tent. It is NOT LEAKAGE through the tent fabric. It can be minimized by removing wet clothing from your tent and by WARNING: Keep clear of overhead power lines.
  • Page 2 Push Here S Hook Sleeve Spring Guyline match Colors Velcro Loop Pole Strap underside of Rainfly The Coleman Company, Inc. • 3600 North Hydraulic • Wichita, Kansas 67219 U.S.A. DISaSSEMBLy 1-800-835-3278 in the United States • www.coleman.com To take down the tent, follow the previous steps and © 2015 The Coleman Company, Inc. All rights reserved. Coleman ® and are registered trademarks of The Coleman Company, Inc. illustrations in the reverse order. 4010042228 (ECN20049198-02)
  • Page 3 INSTRUCTIONS DE MONTagE DE La TENTE Montana Modified Dome, with half fly (Le produit peut sembler différent du vôtre. L’image ne sert que des fins d’illustration.) Avant de commencer Renseignements essentiels: • Lisez toutes les instructions avant d’entreprendre le montage. • Sous certaines conditions (par temps • Ne rangez jamais la tente, même • Choisissez l’emplacement où vous monterez votre tente: froid ou très humide, par exemple) de temporairement, sans la faire plat,sans pierres, branches ou autres objets pointus.
  • Page 4 «S» Passant Piquet Ressort Hauban Couleurs appariées Boucle mât Sangle Côté inférieur du double-toit Sunbeam Corporation (Canada) Limited • DBA Jarden Consumer Solutions DÉMONTagE 20B Hereford Street • Brampton, ON L6Y 0M1 1-800-387-6161 au Canada • www.coleman.com Pour démonter la tente, suivez les étapes et illustrations © 2015 The Coleman Company, Inc. Tous droits réservés. ® Coleman sont des marques déposées de The Coleman Company, Inc. relatives au montage, mais en sens inverse. 4010042228 (ECN20049198-02)