Ch A Pt E R 1 0 . Use T H E Lcd Pa Ne - QNAP HS-210 Hardware User Manual

Cha pt e r 1 0 . Use t he LCD Pa ne l
This feat ure is only available for NAS m odels wit h LCD panels.
LCD Pa n e l – QTS 4 .3 .0 a nd a bove
You can use t he LCD panel t o configure syst em set t ings and view syst em inform at ion. You
can use t he " ENTER" and " SELECT" but t ons next t o t he panel t o navigat e t hrough t he LCD
m enu.
Aft er st art ing t he NAS, you can see it s nam e and firm ware version appear on t he panel.
N A S 5 F 4 D E 3
4 . 3 . 0 ( 2 0 1 6 0 7 0 3 )
Aft er a few seconds, t he panel will be aut om at ically t urned off. Then you can begin t o
configure set t ings or view syst em inform at ion.
Vie w ing syst e m I P a ddr e ss
1. Press " ENTER" or " SELECT" t o t urn on t he panel.
2. Press " SELECT" t o browse t he NAS m odel nam e and t he available I P addresses ( for
each net work and t hunderbolt int erface) .
This feat ure is part icularly useful when t he NAS is near you.
Vie w ing a n d con figur in g syst e m se t t in gs
When t he nam e and firm ware version of t he NAS appear on t he panel, press " ENTER" for
t wo seconds t o view t he Main Menu, which will aut om at ically disappear if no furt her act ions
are perform ed in t en seconds.
There are eight opt ions on t he Main Menu:
1. TCP/ I P
2. Physical disk
3. Volum e
4. Syst em
5. Shut down
6. Reboot
7. Password
8. Back
111