Download
Share
Print this page
TFA 42.5003 Instruction
  1. Manuals
  2. Brands
  3. TFA Manuals
  4. Measuring Instruments
  5. 42.5003
  6. Instruction

TFA 42.5003 Instruction

Hide thumbs
1
2
3
4
5
6
7
8

Advertisement

Quick Links

Download this manual
Instruction Kat.No. 42.5003
Features
- Speedometer
- Odometer
- Tripmeter
- Auto-timer/Stopwatch
- 24-hour clock
- Average speed
- Maximum speed
- Speed Comparison
- Scan
- Wireless
- Km/Mile selection
- Auto/Manual timer selection
- Power saving function
MAIN COMPONENTS
Mounting with CTx & CRx, the unit will function as a wireless cycle computer

Advertisement

loading

Related Manuals for TFA 42.5003

Summary of Contents for TFA 42.5003

  • Page 1 Instruction Kat.No. 42.5003 Features - Speedometer - Odometer - Tripmeter - Auto-timer/Stopwatch - 24-hour clock - Average speed - Maximum speed - Speed Comparison - Scan - Wireless - Km/Mile selection - Auto/Manual timer selection - Power saving function MAIN COMPONENTS...
  • Page 2 ACCESSORIES ATTACHING THE RECEIVER UNIT TO THE HANDLEBAR Step 1 : Put the Unit onto the Handlebar Step 2 : Mounting Shoes Attach the mounting shoes to the handlebar using the bracket screw provided. If the clamp closes completely, or the bracket slips on the handlebar, rubber shims are included to provide secure fit.

  • Page 4: Magnet Mounting

    MAGNET MOUNTING ATTACH THE MAGNET TO THE LEFT SIDE FRONT WHEEL SPOKE WITH THE SCREW PROVIDED. OVER TIGHTENING THE SCREW CAN STRIP THE THREADS. SO USE CAUTION. POSITION THE TRANSMITTER AND MAGNET AS SHOWN, MAKE SURE THE ARC OF THE MAGNET INTERSECTS THE TRANSMITTER'S 'SENSOR' MARKING WITH , 2MM CLEARANCE, ADJUSTING THE DESIRED GAP BY MOVING BOTH THE MAGNET AND THE TRANSMITTER UP AND DOWN.
  • Page 5 Initial Setting Mode (System Reset) The cyclocomputer can be reset anytime by depressing both buttons together over 2 seconds or after battery installation. At reset, the screen shows all segments ON for 2 seconds and data in all modes are CLEARED instantly. The initial setting mode is then entered.
  • Page 6 Speedometer Speedometer is shown on the top line all the time. The current speed updated every 3 seconds is displayed. (Note: The speedometer has a range of 0.0 to 99.9 km/h or mile/h with a resolution of 0.1 km/h or mile/h.) Odometer mode Odometer mode is indicated by "ODO".
  • Page 7 Clock mode Clock mode is indicated by "CLK". The 24-hour clock is displayed. To set the clock, depress the left button over 2 seconds and then release it. Press the left button again to advance the flashing minute or depress it over 2 second for fast advance. Press the right button to confirm the minute set and repeat the procedures to set hour.

  • Page 8: Troubleshooting

    Different Speed mode Different Speed mode is indicated by "DIF". Push mode key (right key) to reach this function. The lower display will show the different speed between the current speed and Ibe average speed (+/-). (Note: The Different speed has a range of -150.0 to 150.0 km/h (or mile/h) and a rest value of 0.0) Scan function Scan function mode is indicated by "SCAN".