Table of Contents
Advertisement
CLEANING
Never use steam cleaning equipment.
Do not use wire wool, abrasive scourers or abrasive/corrosive cleaning agents, as these
could damage the surfaces of the appliance.
Clean the vacuum packing machine with a soft cloth or sponge and neutral detergent.
In order to ensure hygiene and safeguard the quality of foodstuffs packed, the vacuum
chamber and glass lid must be cleaned after each use.
Use a soft cloth or non-abrasive sponge and neutral detergent.
Once a month, clean the sealing bar in order to remove any residue which could negatively
impact the quality of bag sealing.
To facilitate this procedure, lift the sealing bar (2) up, removing it from the two pins. Use a
soft cloth or non-abrasive sponge and neutral detergent.
After cleaning, fit the bar on the pins, lining up the two holes on the underside of the bar
and make sure it engages securely without removing the black teflon pipe.
If you plan not to use the machine for a prolonged period of time, clean it thoroughly.
Before using again, unplug and clean it thoroughly again and restart.
Automatic drying cycle
The packaging machine prompts the need to start a DRYING CYCLE when the signal
Remove from the tray any object and residual liquid.
Press
.
Wait until the end of the cycle. The duration is about 20 minutes. In case of early
interruption, the entire cycle must be repeated.
TROUBLESHOOTING
PROBLEM
All the led indicators on
the control panel flash.
The led indicator of the
STOP button flashes,
accompanied by an
intermittent acoustic
signal
Upon switching on, all
the led indicators on the
control panel flash for
3 seconds and a long
acoustic signal is emitted.
POSSIBLE CAUSE
Overheating.
Insufficient vacuum in the
chamber.
Pump oil replacement reminder.
SOLUTION
Switch the machine off and wait
for approximately 15 minutes to
allow cooling and automatic reset
of the thermal overload cutouts.
If the problem persists when the
machine is switched back on
again, call the after sales service.
Lid not pressed at start of cycle.
Lid of vacuum container not
properly fitted.
Lid seal worn or incorrectly
positioned.
Switch the machine off and wait
for approximately 15 minutes.
If the problem persists when the
machine is switched back on
again, call the after sales service.
Call the Kitchen Aid after sales
service.
lights on.
15
Advertisement
Table of Contents
