Table of Contents
Advertisement
Control Components
Verify that all of the following parts and hardware
have been received prior to beginning installation.
Contact your local representative or the manufacturer if
replacement parts are required.
NOTE: Additional parts (provided by others) may be
required to complete the control installation, including
additional wiring and hardware for mounting the control
to the building structure.
Installation
Using a 2 inch deep single gang outlet box, secure
the control to the outlet box via the top and bottom
mounting holes, which are behind the cover plate of the
control.
1. Identify desired mounting location for the
touchscreen control and mount a 2 inch deep,
single gang junction box (by others) in accordance
with the manufacturer's instructions.
2. Route a shielded, twisted pair CAT-5e
communication cable from the HVLS fan to the
junction box and secure appropriately.
3. Plug the shielded, twisted pair CAT-5e cable into
the RJ45 port on the back of the touchscreen
control, then place the control inside the junction
box.
4. Secure the touchscreen control to the junction box
using the provided installation screws.
5. Once the control is securely mounted, snap the
cover plate onto the front of the control. Make sure
the top side of the cover plate is aligned with the
top side of the control (refer to alignment labels on
control and cover plate).
IMPORTANT: Controls and HVLS fans must be installed
with the supplied CAT-5e communication cable or
shielded, twisted pair CAT-5e (by others) that complies
with the following specifications. Cable must be twisted
pair, shielded 26 ga. CAT-5e cable with a drain wire and
must be compliant with ISO 11801. Cable must use
shielded RJ45 connectors with a soldered drain and
wiring configuration must follow EIA/TIA T568B wiring
pinout. Individual CAT-5e cable lengths must not exceed
200 ft. in order to prevent network communication
issues.
2
HVLS Standard Touchscreen Control
Standard Touchscreen Control (1)
and Installation Screw (2)
NOTE: Control is powered via shielded, twisted pair
CAT-5e communication cable from the HVLS fan(s). No
additional power source is required.
TOUCHSCREEN CONTROL
INSTALLATION SCREW
COVER PLATE
Cover Plate (1)
JUNCTION BOX
(BY OTHERS)
®
Advertisement
Table of Contents
