Saving Edited Programs - Yamaha REV500 Operation Manual

REVERB ➔ TREMOLO
In this effect type, the output from the reverb is fed into a tremolo effect.
Parameter Ctrl. No.
SPEED
DEPTH
PHASE
WAVE
ECHO ➔ REVERB
In this effect type, the output of the reverb's PRE DELAY block is fed back into the reverb input to produce
an echo effect.
Parameter Ctrl. No.
FB LVL
CROSS FB

Saving Edited Programs

You must save the programs you have edited before
selecting a different program or turning off the REV500, or
the changes you make will be lost.
To save a program, press the STORE key. The program
number in the LCD will begin to flash, and the REV500 will
ask you if it's okay to store the program. (If you are editing a
preset program, the memory area indicator under the
program number will automatically change to USER.)
Range
78 0.05 — 10.0 [Hz]
79 0 — 100 [%]
80 0 — 354.4 [°]
81 SINE, TRI, SQR
Range
82 -100 — +100 [%]
83 -100 — +100 [%]
Description
Modulation frequency
Modulation depth
Phase difference between right and left channels
Waveform used by low frequency oscillator
Description
Level of feedback to own channel
Level of feedback to opposite channel
If you want to save your program under a different program
number, use the PROGRAM NUMBER keys to change the
program number. (You cannot change the program type,
however.) Press STORE a second time when you are sure
you're ready to save the program, and the REV500 will
comply.
If you decide you'd rather not store the program after all,
simply press the PROGRAM TYPE key or the PRESET/
USER key, and the display will return to normal.
13