Standby Mode; Notes About The Remote Control Transmitter - Yamaha AX-470 Owner's Manual

STANDBY mode

<
For AX-470 and Europe model of AX-570
While the power is on, pressing the POWER key on the remote
control transmitter switches the unit to the STANDBY mode.
(In this mode, the indicator is half illuminated.)
Note
The POWER switch on the front panel of this unit should
be turned off when left unused for a long period of time.

NOTES ABOUT THE REMOTE CONTROL TRANSMITTER

Battery installation
3
2
Battery replacement
If you find that the remote control transmitter must be used
closer to the main unit, the batteries are weak. Replace both
batteries with new ones.
Notes
Use only AA, R6, UM-3 batteries for replacement.
Be sure the polarities are correct. (See the illustration inside
the battery compartment.)
Remove the batteries if the remote control transmitter will
not be used for an extended period of time.
If batteries leak, dispose of them immediately. Avoid
touching the leaked material or letting it come in contact with
clothing, etc. Clean the battery compartment thoroughly
before installing new batteries.
>
1
<
AX-470
POWER on mode
<
Europe model of AX-570
POWER on mode
Remote control transmitter operation range
Remote control
sensor
Notes
There should be no large obstacles between the remote
control transmitter and the main unit.
If the remote control sensor is directly illuminated by strong
lighting (especially an inverter type of fluorescent lamp etc.),
it might cause the remote control transmitter not to work
correctly. In this case, reposition the main unit to avoid
direct lighting.
>
STANDBY mode
>
STANDBY mode
Within approximately
7 m (23 feet)
11