The Pattern Jobs; 00: Undo/Redo - Yamaha QY 300 Owner's Manual

The pattern mode includes 7 pattern "jobs" that perform a variety of important functions. To
access and use the pattern jobs, press the
the pattern job list. You can select any job on the list simply by moving the cursor to the
required job (use the cursor keys or the data dial) and pressing
up or down the list in 1-page steps by using the cursor
[SHIFT]
of the keys. An alternative method is to enter the job's number via the numeric
keypad and press

00: Undo/Redo

86
[ENTER].
Returning to the PATTERN Mode
The [F6] function key ("Exit") can be used to exit from any pattern job, and
then from the job list thereby returning you to the PATTERN mode. You can
also press the [F6] function key ("Exit") while holding one of the [SHIFT]
keys to directly return to the PATTERN mode.
This job will "undo" any other pattern job, edit, or record function if it is
executed before any other operation is performed. In all cases the affected data
is restored to the state it was in before performing the job, edit, or record
operation. This job will also undo the last undo operation (redo).
The name of the last operation performed will appear on the display (i.e. the
operation which will be "undone"). In the example display, above, a quantize
operation will be undone.
[JOB]
key while in the PATTERN mode. This calls
and
[ENTER].
You can also move
keys while holding one