Assembly - Sharper Image SI-380 Owner's Manual

ASSEMBLY

STEAM MOPPING ACCESSORIES
WARNING: Do not try to connect accessories while unit is emitting steam.
EXTENSION WANDS
1. Select one of the Extension Wands. Insert end (A) of Wand onto Steam Nozzle
(B) with orange lock/release button slightly off center with hole. Fully insert and
rotate wand slightly to allow button to snap into hole.
2. Using the same instruction, attach remaining Extension Wand (C) to the first
Wand. Both Extension Wands should now be connected to the Steam Nozzle.
MOP HEAD
1. Align Mop Head with open end of Extension Wand, so that hole in Mop Head
aligns with orange lock/release button on Wand.
2. Press down on orange lock/release button. While continuing to hold button
down, slide Mop Head onto Extension Wand (See figure 1-A). Fully insert and
rotate wand slightly until button snaps through hole (See figure 1-B).
NOTE: Do not use excessive force when mopping or using Extension Wands as this
may cause the Wands to break.
FIGURE 1
A
MICROFIBER PADS
1. Lay one Microfiber Pad on flat surface, with two fastener strips facing upward.
2. Align Mop Head with Microfiber Pad. Make sure Mop Head is oriented with Pad
as shown, and centered as best as possible (See figure 2-A).
3. Press Mop Head firmly down onto Microfiber Pad. Fastener strips will adhere to
10 English
C
B
A
B