Epson TM-T88 Series Technical Reference Manual page 43

Selection of the energization parting
• One-part energizing (default setting)
• Two-part energizing
• Three-part energizing
• Four-part energizing
· In normal operation, there is no need to change the energization parting.
· The maximum print speed is available only in the one-part energizing mode.
· Four-part energizing mode can reduce power consumption.
Selection of printing density
Models
Other than the 68*
model
68* model
Depending on the paper type, it is recommended to set the print density as shown in the table below for
the best print quality.
Thermal paper (without black marks):
Original Paper type
P35524, P30523, P31523
TF50KS-EY, F5041(55), KT55FA, KT48FA
AF50KS-E
KF50
Liner-free label paper (with black marks):
Original Paper type
9023–1274, 9023–1253 (Lane coated: 80 mm)
9023–1823, 9023–1397 (Lane coated: 58 mm)
9023–1275, 9023–1257 (Lane coated: 40 mm)
When the print density level is increased, print speed may be reduced.
Media type
Thermal paper
Liner-free label paper
Thermal paper
Liner-free label paper 75 - 100% (in increments of 5%)
Chapter 3 Advanced Usage
Density setting
100 - 130%
(in increments of 5%)
Fixed
100 - 130%
(in increments of 5%)
Density
120%
115%
110%
100%
Density
Other than the
68* model
Fixed
Fixed
Fixed
Default setting
120%
Fixed
120%
100%
Density
68* model
100%
100%
100%
43
3