Advertisement
Quick Links
Advertisement
Related Manuals for Meridian DT-2V2K/2K
Summary of Contents for Meridian DT-2V2K/2K
- Page 1 Installation/Operation Instructions Fiber Optic Video/Data Transmission System Part Number: DT-2V2K/2K (Video Transmitter/Data Transceiver) DR-2V2K/2K (Video Receiver/Data Transceiver) 700 Elmont Rd, Elmont, NY 11003, Tel: 516-285-1000; Fax: 516-285-6300 www.Meridian-tech.com Page 1...
-
Page 2: Table Of Contents
Table of Contents PRODUCT DESCRIPTION.................3 INSTALLATION..................3 PRODUCT SIGNAL FORMAT & SPECIFICATIONS .........3 DATA SIM SIGNAL ASSIGNMENT (PINOUTS) ........4 OPTICAL SPECIFICATIONS ..............5 TROUBLESHOOTING................6 700 Elmont Rd, Elmont, NY 11003, Tel: 516-285-1000; Fax: 516-285-6300 www.Meridian-tech.com Page 2... -
Page 3: Product Description
Meridian’s standard chassis (SR-1000/S, SR-1200/S, SR-1500/S, and SR-2001 & SR-2000 series 19” equipment chassis). To install in the chassis, orient the card with the Meridian logo at the top of the module and slide onto the top and bottom card guides in the chassis. Press securely on the top and bottom of the module to ensure that it is fully seated in the chassis so that the electrical connector mates with the chassis-mounted motherboard. -
Page 4: Data Sim Signal Assignment (Pinouts)
RS-485 (4-wire) data channels. The data SIM has a DB9 female connector. The table below shows the appropriate pinout for each of the connectors RS-485 Data Connector Pinout Assignment (Port #4) Pin # DT-2V2K/2K DR-2V2K/2K Ch1 OUT (+) Ch1 IN+ Ch1 OUT (-) -
Page 5: 5.0 Optical Specifications
DT-2V2K/2K (4-wire) DR-2V2K/2K (4-wire) Figure 4.1 Figure 4.1 Front Panel Layout/Pinout Diagrams Front Panel Layout/Pinout Diagrams 5.0 Optical Specifications 5.0 Optical Specifications Optical Specifications Optical Specifications Fiber Type/Size Optical Optical Wavelength Optical Optical (um) Output Sensitivity Budget (nm) connector Dynamic... -
Page 6: Troubleshooting
Module does not fit in chassis slots Action: Check module orientation. Meridian “Globe” must be oriented on the top left hand side of the module Make sure the card guides in the chassis are aligned with the extrusion on the module...