Before Using The P-70; Turning The Power On; Setting The Volume - Yamaha P-70 Owner's Manual

Before Using the P-70

Turning the Power On

1.
Connect the PA-5D power adaptor's DC
cable to the [DC IN 12V] jack.
2.
Plug the AC adaptor into an AC outlet.
WARNING
Use ONLY a Yamaha PA-5D AC Power Adaptor (or other adaptor spe-
cifically recommended by Yamaha) to power your instrument from
the AC mains. The use of other adaptors may result in irreparable
damage to both the adaptor and the P-70.
CAUTION
Unplug the AC Power Adaptor when not using the P-70, or during
electrical storms.
3.
Press the [STANDBY/ON] switch to turn
the power on.
The power indicator located to the left of the
switch lights up.
When turning off the power, press and hold down the [STANDBY/ON] switch for a short time until the
NOTE
power turns off. The P-70 uses this power-off procedure as a "safety" device to prevent the power from
being inadvertently turned off during performance.
CAUTION
Even when the instrument is turned off, electricity is still flowing to the instrument at the minimum level.
When you are not using the P-70 for a long time, make sure you unplug the AC power adaptor from the
wall AC outlet.

Setting the Volume

Initially set the
[MASTER VOLUME]
playing, re-adjust the
[MASTER VOLUME]
TERMINOLOGY MASTER VOLUME:
The volume level of the entire keyboard sound
[STANDBY/ON]
slider about halfway between the "MIN" and "MAX" settings. Then, when you start
slider to the most comfortable listening level.
The level decreases. The level increases.
Before Using the P-70
(The shape of plug
differs depending on
locale.)
P-70 Owner's Manual
11