Table of Contents
Advertisement
Available languages
Available languages
Technical Data
30" (4 burners):
Total connected load, electric
Total connected load, gas
(natural gas)
Total connected load, gas
(propane gas)
36" (6 burners):
Total connected load, electric
Total connected load, gas
(natural gas)
Total connected load, gas
(propane gas)
Installation Procedure
An air curtain or other overhead range hood, which
operates by blowing a downward airflow onto a range,
shall not be used in conjunction with the gas range
unless the hood and range have been designed and
tested in accordance with ANSI Z21.1 and listed by an
independent testing laboratory for combination use.
Prepare Installation Space
Installing the Bracket with Recess Depth up to 24"
Measure the width of the slot for the appliance.
1.
Divide the measurement in two and trace the midline
2.
on the furniture's floor.
8
0.001 A
0.1 W
47,000 BTU/h
(13.7 kW)
47,000 BTU/h
(13.7 kW)
0.001 A
0.1 W
77,000 BTU/h
(22.5 kW)
77,000 BTU/h
(22.5 kW)
I n s t a l l a t i o n P r o c e d u r e
P r e p a r e I n s t a l l a t i o n S p a c e
Installation Checklist
Please refer to the pages following for complete
installation instructions. Use this checklist to verify that
you have completed each step of the installation
process. This can help you avoid mistakes.
Installation step
è
Before installing the cooktop, be sure to verify
the cabinet dimensions are correct for your unit
and that the required electrical and gas connec-
tions are present.
Before installing the cooktop, make sure that
any opening in the wall behind the appliance
and in the floor under the appliance shall be
sealed.
Refer to the installation manual for content
regarding Safety, Cabinet Dimensions, Remov-
ing Packaging, Electrical Installation, Gas Con-
nection, and Customer Service.
Plug the cooktop into a properly configured
receptacle.
Measure from the wall 21" (about 534 mm) and trace
3.
a line perpendicular to the midline.
Put the bracket approximately as in the figure below, in
4.
the middle of the two lines (since it's not necessary to
be more precise because the slot in the range top's
floor provides enough clearance) and trace the center
of the bracket's holes or fix it directly with the screws.
Advertisement
Chapters
Table of Contents
