Controlling A Dme Satellite's Internal Head Amps From A Digital Mixer; Controlling The Dme Satellite From An External Device - Yamaha DME4io-ES Owner's Manual
Yamaha digital mixing engine satellite owners manual
Hide thumbs
Also See for DME4io-ES:
- Service manual (196 pages) ,
- Manual de instrucciones (48 pages) ,
- Setup manual (23 pages)
Table of Contents
Advertisement
Connecting to an External Device
Controlling a DME Satellite's internal head amps from a digital mixer
The internal head amp settings of a DME8i-ES or DME4io-ES can be remotely controlled from a digital mixer
such as the Yamaha PM5D or DM2000.
Connect the digital mixer to the DME series' [REMOTE] connector, and use an Ethernet cable to make connec-
tions between the [NETWORK] connectors of the DME series.
From the digital mixer, DME series units can be controlled as an AD8HR. The gain and the phantom power
(+48V) can be controlled.
Digital Mixer
NO T E
• Only one mixer can be connected within each device group.
• The digital mixer can be connected to any DME series unit, whether it is the group master or a slave unit.
• The ID number of the DME series unit being remotely controlled is specified from DME Designer.
For details on making this setting, refer to the "DME Designer Owner's Manual."
• If the connection between DME series units is broken, it will no longer be possible to communicate with DME units of an
ID number that follows the disconnected DME.
Controlling the DME Satellite from an external device
You can remotely control the DME Satellite from a connected RS-232C or RS-422 compatible controller, such
as those from AMX or Crestron.
Be sure to set the dip switch on the rear panel of the DME Satellite correctly (page 16) in accordance with a con-
nected RS-232C or RS-422 compatible remote controller. Do not change the dip switch setting to any other po-
sition while the devices are connected to prevent possible damage to the device(s).
NO T E
• The port used for remote control is specified from DME Designer. For details on making this setting, refer to the "DME
Designer Owner's Manual."
• Refer to "DME Remote Control Protocol Specifications" on the Yamaha web site for more information on communication
protocols used to control the DME Satellite from an external device (such as those from AMX or Crestron).
http://www.yamahaproaudio.com/
D-SUB 9-pin Cable
REMOTE
DME Satellite
DME Satellite
DME Satellite
DME Satellite
REMOTE
Ethernet
Cable
DME8i-ES/DME8o-ES/DME4io-ES Owner's Manual
Switching
Hub
27
Advertisement
Table of Contents
