Connecting To An Ibm-Pc/At Series Computer - Yamaha Clavinova CLP-920 Owner's Manual

Connecting to a Personal Computer
IBM-PC/AT
Series Computer
Set to the "PC-2" position.
Mac MIDI
PC-1 PC-2
TO HOST HOST SELECT
• If your system doesn't work properly with the connections and settings listed above, your software may require
NOTE
different settings. Check your software operation manual and if it requires a 31,250 bps. data transfer rate, set the
HOST SELECT switch to "PC-1".
• When using the TO HOST terminal to connect to a personal computer using Windows, a Yamaha MIDI driver must
be installed in the personal computer. The Yamaha MIDI driver can be obtained at Yamaha's home page on the
World Wide Web, <http://www.yamaha.co.jp/english/xg/>.
16
CLP-920

Connecting to an IBM-PC/AT Series Computer

Connect the TO HOST connector of the Clavinova to the RS-232C port
on your IBM computer, using a standard 8-pin MINI DIN → 9-pin D-SUB
cross cable. Set the HOST SELECT switch to the "PC-2" position.
Refer to your software owner's manual for information on any
settings you might have to make on the computer side.
G "PC-2" Cable Connections
MINI DIN
8-PIN
• 8-pin mini DIN → 9-pin D-SUB cable.
• Data transfer rate: 38,400 bps.
G Connector Pin Numbers
MINI DIN 8-PIN
6 7 8
3 4 5
1 2
D-SUB 9-PIN
5 4 3 2 1
9 8 7 6
1
2
3
4
8
5
............
8 (CTS)
D-SUB
7 (RST)
9-PIN
2 (RxD)
5 (GND)
3 (TxD)