Yamaha Clavinova CLP-555 Owner's Manual page 48

Yamaha musical instrument owner's manual
Hide thumbs Also See for Clavinova CLP-555:
Table of Contents

Advertisement

<
Remove the protective backing from the adhesive surface of
the cord holders, and attach at approximately the locations shown
in the illustration. Plug the main-unit end of the AC cord into the
corresponding socket on the bottom of the main unit, then secure
the cord with the cord holders.
A plug adaptor may be also provided in some areas to match
the pin configuration of the AC wall outlets in your area.
>
For stability, an adjuster is provided on the bottom of the
pedal box (D). Rotate the adjuster until it comes in firm contact
with the floor surface. The adjuster ensures stable pedal operation
and facilitates pedal effect control. If the adjuster is not in firm
contact with the floor surface, distorted sound may result.
m Review the assembly procedure and correct any errors.
m Move the Clavinova to an appropriate location.
m Tighten all screws.
m Turn the adjuster so that it is set firmly against the floor.
m Check the connection.
46
<
Ziehen Sie das Schutzpapier von der Klebefläche der
Kabelhalter ab, und bringen Sie die Halter ungefähr an den in der
Abbildung gezeigten Stellen an. Stecken Sie den kleineren Stek-
ker des Netzkabels in die entsprechende Buchse an der Unterseite
des Instruments, um das Kabel dann in die Kabelhalter zu legen.
In manchen Gebieten wird ein Steckerdapter mitgeliefert, um
den Anschluß an die evtl. unterschiedlich geformte Steckdose zu
ermöglichen.
>
Um dem Pedalkasten (D) mehr Standfestigkeit zu geben, ist er
mit einem verstellbaren Pedalfuß ausgestattet. Drehen Sie diesen
Fuß heraus, bis er fest auf der Bodenfläche steht. Der Pedalfuß
stabilisiert den Pedalkasten und ermöglicht eine präzise Pedal-
betätigung. Wenn der Pedalfuß nicht fest auf dem Boden steht,
können Klangverzerrungen auftreten.
m Gehen Sie den Vorgang des Zusammenbaus noch einmal durch und
korrigieren Sie eventuelle Fehler.
m Bewegen Sie das Clavinova an einen entsprechend sicheren Ort.
m Ziehen Sie alle Schrauben fest.
m Drehen Sie den Höhenversteller, bis er fest auf dem Fußboden steht.
m Prüfen Sie die Verbindung.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents