Yamaha AN1x Owner's Manual page 106

Next let's tweak a few parameters to add extra
control over and dimension to the sound...
5. Set up the [MODULATION] wheel to control
the speed of the rotary speaker.
Set the [EDIT ROTARY] switch to the VOICE SCENE
SETUP menu.
• Press Control Matrix Set No [UP/DOWN] to select
"Comn1" (Common 1).
• Press Param [UP/DOWN] to select "Vari Param"
(Variation Parameter).
• Press Source [UP/DOWN] to select "A.MW"
(Modulation Wheel). When you move the
[MODULATION] wheel, the speed of the rotary
speaker will change accordingly.
• Press Depth [UP/DOWN] to set the value to
"Dp+10".
6. Add the organ click to the sound using the
PEG.
Press KNOB PARAMETER GROUP switch [PEG/LFO].
• Turn CONTROL knob 1 to set the PEG Decay
parameter to a value between "+1" and "+4".
• Turn CONTROL knob 2 to set the PEG Depth
parameter to a value of about "+20". This creates
the click.
There are many other parameters you may
want to adjust to get just the right sound you
want. When you're finished with the editing
process, perform a Voice Store operation to
store your creation. For information, see page
98.
Synth Brass
First let's create the fundamental sound...
1. Select a voice that you don't mind writing
over.
Perform a Type 1 (Normal) Voice Initialize operation.
2. To achieve the sound of multiple players,
we'll use both VCO1 and VCO2 oscillators.
Press KNOB PARAMETER GROUP switch [MIX/VCF],
then press CONTROL knob 2 once to display the
VCO2 Level parameter in the LCD. Turn the knob to set
a value of "127" so that the VCO2 can be heard.
3. Adjust the interval between the oscillators.
Press KNOB PARAMETER GROUP switch [VCO2], then
press CONTROL knob 3 once to display the Fine Tune
parameter. Turn the knob to set a value of about "-4" to
create a slight interval.
4. Set up the FEG, VCF Cutoff and FEG Depth for
a characteristic brass sound.
Press KNOB PARAMETER GROUP switch [VCF].
• Turn CONTROL knob 1 to set the Attack parameter
to about "40".
• Turn CONTROL knob 2 to set Decay to about "55".
• Turn CONTROL knob 3 to set Sustain to about "40".
• Turn CONTROL knob 5 to set the VCF Cutoff to
about "55".
• Turn CONTROL knob 7 to set the FEG Depth to
about "+55".
Next let's tweak a few parameters to add extra
depth and dimension to the sound...
5. Emphasize the brass characteristics of VCO1
with the PEG.
Press KNOB PARAMETER GROUP switch [PEG/LFO].
• Turn CONTROL knob 1 and set the PEG Decay value
to about "+15".
• Turn CONTROL knob 2 and set the PEG Depth
parameter to about "-2".
• Turn CONTROL knob 3 and set the PEG Sw (Switch)
to "VCO1".
106