Yamaha AN1x Owner's Manual page 105

12. Use the Control Matrix to control the Sync
Pitch by key tracking.
With key tracking you can mellow out the Sync Pitch in
the upper range and bring out the grit in the lower
range.
In the VOICE SCENE SETUP menu, perform the
following operations:
• Press Set No [UP/DOWN] to display "Set 3" in the
LCD.
• Press Param [UP/DOWN] to display "Sync Pitch" in
the LCD.
• Press Source [UP/DOWN] to display "KyTrk" (Key
Track) in the LCD.
• Press Depth [UP/DOWN] to set a value of "Dp-18".
Finally, let's adjust the PEG to add a harder attack to
the electronic piano sound. Press KNOB PARAMETER
GROUP switch [PEG/LFO].
• Turn CONTROL knob 1 and set the PEG Decay
parameter to about "+3".
• Turn CONTROL knob 2 and set the PEG Depth
parameter to about "10".
There are many other parameters you may
want to adjust to get just the right sound you
want. When you're finished with the editing
process, perform a Voice Store operation to
store your creation. For information, see page
98.
Electronic Organ
First let's create the fundamental sound...
1. Select a voice that you don't mind writing
over.
Perform a Type 1 (Normal) Voice Initialize operation.
2. Select the pulse wave for a basic organ
sound.
Press KNOB PARAMETER GROUP switch [VCO1]. Turn
CONTROL knob 1 to set the Wave parameter to
"pulse". Turn CONTROL knob 4 to set the Edge
parameter to a value of about "30". This smooths out
the rough edge of the sound.
Press KNOB PARAMETER GROUP switch [SYNC/FM].
• Turn CONTROL knob 1 to set the Algorithm
parameter to "Sync+FMbth", which enables the sync
and applies FM to both master and slave oscillators
of VCO1.
NOTE Other settings (except for "only FM") will also produce effective results.
• Turn CONTROL knob 2 to set the Sync Pitch
parameter to a value of about "+17".
3. Set up the VCO2 an octave down to add
fullness to the organ sound.
Press KNOB PARAMETER GROUP switch [VCO2].
• Turn CONTROL knob 4 to set the Edge parameter to
a value of about "40".
• Turn CONTROL knob 2 to lower the Pitch parameter
to a value of "-12", which is a full octave down.
Press KNOB PARAMETER GROUP switch [MIX/VCF].
• Turn CONTROL knob 2 to set the VCO2 Level to a
value of "127" so that the VCO2 can be heard.
• Turn CONTROL knob 1 to decrease the VCO1 Level
to a value of about "70".
4. Add a rotary speaker effect to the organ
sound.
Set the [EDIT ROTARY] switch to the VOICE COMMON
menu.
• Press Vari EF/EQ Param [UP/DOWN] to display
"VarEF" in the LCD.
• Press Data [UP/DOWN] to select the "RotarySp"
effect.
• Press Vari EF Dry:Wet [UP/DOWN] to increase the
effect level to a value of about "D<W10".
105