Table of Contents
Advertisement
Installation
Installing the Keyboard Wedge Reader
To install a keyboard wedge reader, follow the steps below:
1.
Turn off the power of the PC or Terminal.
2.
Unplug keyboard from the PC or Terminal.
3.
Make sure you have the Y cable with appropriate
connector type for your PC or Terminal.
4.
Connect Scanner to your PC or Terminal.
5.
Connect the keyboard connector to the female connector
of the Y cable
6.
Turn on the power of PC or Terminal.
Installing the RS232 Reader
To install a RS232 reader, follow the steps below:
1.
Turn off the power of the PC or Terminal.
2.
Make sure the connector type from RS232 to the PC or
Terminal is correct.
3.
Plug AC Adaptor connector into connector of the reader.
4.
Turn on the power of PC or Terminal.
5.
Setup the Interface of the reader to RS232 mode by
scanning the barcode in the Interface Selection.
2
Advertisement
Table of Contents
