Table of Contents
Advertisement
PRODUCT SPECIFIC SAFETY WARNINGS
> Always position the Crown-Cut on the
miter saw so that it is clear of the blade's
cutting path by at least 1/2".
> Hold the Crown-Cut and molding securely
against the fence of the miter saw when
making cuts.
> Always position moldings upside down on
the Crown-Cut. The jig will not produce
the desired results if the molding is not
positioned upside down.
> For best results, always provide adequate
support for long moldings.
2 4
> Keep hands and fingers out of the path of the saw blade.
Maintain awareness of the blade at all times.
> Never cut cross-handed.
> Always allow the blade to come to a
complete stop before lifting the miter saw
handle and removing the Crown-Cut, the
molding and/or any offcut pieces.
> Do NOT attempt to cut pieces shorter
than 7".
> Always make tests cuts in scrap
molding to verify the fit of the joint
before cutting your final workpieces.
Advertisement
Table of Contents
