Attaching The Frame; I About The Strap Pin - Yamaha Silent Guitar SLG-120NW Owner's Manual

When shipped from the factory, the left frame is not attached to the Silent Guitar's
main body.
Before using the instrument, please properly attach the left frame using the proce-
dure described below.
1.
Fully loosen [frame attachment screw 1] located in the
th
area behind the 12
located at the end of the Silent Guitar's main body.
2.
Insert the lower rod of the left frame fully into the bracket
hole on the Silent Guitar's main body.
Next, insert the upper rod fully into the bracket hole.
• Make sure that the upper and lower ends of the left
frame are not reversed.
• Do not place any excess force on the frame's rods.
The rods may become damaged.
3.
After confirming that both rods of the left frame are fully
inserted, turn the attachment screws clockwise and se-
cure the left frame to the Silent Guitar's main body.
• When moving any movable parts, make
sure that your fingers or hand do not
become pinched in the parts.
• Do not tighten the attachment screws
when the frame is removed. It will re-
sult in the damage of parts, which will
cause problems when re-attaching the
frame.
Attachment of the frame is now complete.
To remove the frame, simply reverse the order of the procedure described above, removing the upper
rod from tha main body before removing the lower rod.
• After the frame is attached, make sure attachment screws 1 and 2 are tightened firmly. Using the instru-
ment with the screws loose will result in rattle or other noise during performance.
• When transporting the instrument, please carry the instrument by its neck or main body. Holding the
instrument by only its left or right frame will result in damage of the frame or the frame's fixed parts.

I About the Strap Pin

The frame attachment screw can be used as a strap pin for a separately purchased guitar strap.
• Make sure that the strap is firmly hooked onto the strap pin so the instrument does not drop during
performance.

Attaching the Frame

fret, and [frame attachment screw 2]
Frame attachment screw 1
w
Rod
q First, insert the
OPEN
lower rod into the
main body.
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC
RULES. OPERATION IS SUBJECT TO THE FOLLOWING
TWO CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE
HARMFUL INTERFERENCE, AND (2) THIS DEVICE MUST
ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING
INTERFERENCE THAT MAY CAUSE UNDESIRED
OPERATION. w Then, insert the
• THIS CLASS B DIGITAL APPARATUS COMPLIES WITH
CANADIAN ICES-003.
• CET APPAREIL NUMÉRIQUE DE LA CLASSE B EST
CONFORME À LA NORME NMB-003 DU CANADA.
SILENT GUITAR
MODEL SLG-100N
AC POWER ADAPTOR :
YAMAHA PA-1E OR PA-3C OR PA-D09
BATTERY : 9V 6LR61 OR 6F22
MADE IN INDONESIA N89
upper rod.
AUX VOL
MIN MAX
AUX IN
LINE OUT
Rod
q
Frame attachment screw 2
7