Ryobi P524 Manual

NOTE: These instructions supplement the VARIABLE SPEED LEVER
instructions located on page 7 in your operator's manual.
WARNING:
This insert sheet is not a substitute for reading the operator's manual.
To reduce the risk of injury or death, user must read and understand
operator's manual before using this product. All page references
refer to the operator's manual.
VARIABLE SPEED LEVER
See Figure 1.
The variable speed lever, located on the top of the tool, allows the
saw to operate at different maximum speeds. The maximum speed
can be adjusted before or during operation. To change the maxi-
mum speed during operation, hold the saw in a normal operating
position, fully depress the switch trigger, and slide the lever forward
or backwards. To change the maximum speed prior to operation,
slide the lever forward or backwards, and then depress the switch
trigger to operate the saw between 0 SPM and the preset maximum.
ONE WORLD TECHNOLOGIES, INC.
P.O. Box 1288, Anderson, SC 29622 • Phone 1-800-525-2579
États-Unis, Téléphone 1-800-525-2579 • USA, Teléfono 1-800-525-2579
www.ryobitools.com
18 VOLT BRUSHLESS JIG SAW
SCIE SAUTEUSE SANS BALAIS DE 18 V
SIERRA DE VAIVÉN SIN ESCOBILLAS
DE 18 V
P524
OFF Setting the variable speed lever in the OFF position
will make the saw inoperable to help reduce the
possibility of accidental starting when not in use.
Slow speeds are ideal when minimum speed and
power is required, for example, starting cuts.
Medium speeds are suitable for cutting hard metals,
plastics, and laminates.
Maximum speeds produce best results when
maximum power is required, for example, cutting
wood. Soft metals such as aluminum, brass, and
copper may also require high speeds.
Fig. 1
A - Variable speed lever
(gâchette à vitesse variable,
palanca de velocidad
variable)
B - Off position (éteindre,
posición apagado)
C - Increase cutting speed
(augmenter la vitesse
de coupe, aumentar la
velocidad de corte)
D - Decrease cutting speed
(réduire la vitesse de coupe,
disminuir la velocidad de
corte)
995000624
6-26-18 (REV:01)
B
C
A
D